HIKVISIONindoor Junction Box Deep Base for DS-1280ZJ-XS Network Bullet Camera - White

These Hik-Vision junction boxes are excellent quality. I don't personally fit Hik-Vision Camera systems as I think they're rather over rated and expensive for what you get, however these Hikvision junction boxes are just fantastic.They fit the Reolink B800 perfectly. Only issue with the PoE IP cams is they come with an RJ45 Socket, Power, Reset lead and it can be a little tricky to fit in these boxes, however I have fitted 50+ of these now without any issue, the option to have rear entry or bottom entry cable is fantastic with the included glands which are also excellent quality.They have a nice little metal wire which means you can hang your camera from inside the box whilst you're making your terminations etc and fiddling about getting the excess wire to fit.In summary, they make the job very neat and less of an eye saw having separate bulky plastic junction boxes. I love how all cables are hidden!

Box is thoughtfully designed and solidly built. Supports three different sizes of camera base with enough room for housing the necessary connectors. Once on the wall and with camera, enclosure is fully waterproof thanks to the various washers, gaskets and blanking caps ensuring rain stays out. Comes with plugs and screws for wall mounting, and screws for the camera. I used a 6mm bit for the wall plugs. Has a drill template sticker so you don't even need a pencil. Appertures just wide enough to pass a BNC connector through.I know it's just a camera junction box, but I appreciate good design when I see it.

Does the job... bit pricey for what it is... and would have preferred a smaller cable opening the gap is big enough to fit an rj45 through.

I recently set about upgrading my cctv system which included pretty much a whole new system.Whilst settling on Hikvision cameras I noticed you could get a junction box/mount which is ideal for my. The mount is well made but still light and allows for cables in with a water proof entry whilst the mount itself has plenty of room for cable with a rubber vent for the camera cable to enter the box.This saves on having additional junction boxes and gives the camera clearance from the wall. This particular base can accommodate a few different cameras.

These are described as “deep base” junction box. But they certainly are not. There was very little room inside to fit the connection cables. Most of the inside of the box is taken up by the poorly designed face plate onto which you fit the camera. Look elsewhere for something of better design.

The junction box is of decent material and put together nicely, you should be perfectly fine fitting the RLC-410W as I have done despite being made for HikVision DS-1280ZJ-XS Network Bullet Camera, this also cost £10-£15 cheaper than the official Reolink Junction box which was good.I did take extra pre-cautions to use silicon sealant around the edges and extra screw holes that will not be used, it does get a little tight when placing in the Lan / Reset cables, but does fit.Two nice little added bonuses are the screws to the lid will not fall out when unscrewed and the lid part has a little cable that attaches to the body so when up the ladder it will not fall off.It has been up about a month now in various weathers, so far so good.

Work well

Not good, used hik vision camera the holes on the base don't line up I had to redrill very frustrating turned a two minute job into into a twenty minutes job.