MGI SpeedWareBraided Split-Sleeve Wire Loom for High-Temperature Automotive Harness and Home Cable Management 25 feet (1/2")

After putting the wire inside the wire loom it makes running new wire in a car look professional. Would buy again.

Was pretty easy to install over wiring. Seems pretty tough, have no doubt it's abrasion resistant. Unsure about heat resistance yet but is better than the factory looms so I bet it's great

Very high quality installed after I installed my header collectors on my truck and so far it’s keeping all my wires safe, will continue buying.

Bought this product to enclose wire bundles on 22 Honda Gold Wing Tour DCT. At first I installed zip ties on the wire bundles then covered them with the MGI SpeedWare Braided Split-Sleeve Wire Loom. The heads on the zip ties showed through as small bumps. The product has sufficient curl to keep it closed over the wire bundles without the bundles being zip tied. So, I removed the loom material, removed the zip ties and re-installed the wire loom. Great closure and bundles are secure and the loom material is smooth and has a professional finished appearance. Quality product!

This is a great product and far better than that corrugated plastic sleeve that melts easily. The only problem is that the seller did not measure carefully and my 10ft order was actually 5 in short. I needed two lengths of 5ft for my project and now have to buy more. Waste of time and money and extra product I don't need.

Like the fit and price.

Used to protect toro snowblower auger cable from melting due to poor placement by exhaust.

Was impressed how thick/strong the weave was compared to other wraps I’ve used. Does fray at the end when you cut it though. Works well nevertheless.

I bought this for my motorcycle originally, mostly due to it being more flexible than the harder plastic split wire cover. The braided part does not appreciate being cut, and I used a shrink tube heater originally to try to stop the fraying. Does not leave a nice appearing end though. Now I open the wrap up completely, and put a wrap of electrical tape on both sides of the wrap where I am going to cut it. Then I use sharp scissors (the "good" scissors, best done when home alone) to make the cut through the tape. The tape will keep the end from fraying. If by chance I can disconnect the harness at the ends, I put shrink wrap over the cut end.

For those of you wondering, it looks almost identical to the stuff that Holley uses on there wiring harnesses, but has a little bit tighter weave. (See pic, holley on the left). Works good, no easier to install than the plastic stuff, but looks nicer.

I originally bought these to protect cables for an E-Bike, but I only needed about 2 meters of the stuff, as they only sell them 25ft (7.62m) for all sizes at the lowest. I picked the split 3/4 (19mm) option just in case I wanted to use the rest of the wire loom for my computer desk and game consoles at home.This material does an effective job of keeping the elements away from my E-Bike cables, while making it look more stylish as well. They can be easily cut with scissors but require a lighter or match/hot knife. They advertise that the split version cannot stretch, but has 25% overlap. The cable I recieved looked more like it was 50-75% overlapped which implied that I could store more cables! The split sleeve design is great for cables that lead in different directions so as to not change or alter your setup.Is this worth the price? Only if you have a bunch of cables that are not "trained" or look messy in general or if you need to protect cables for your car/desk/device etc. Always pre-measure what length you need/want first. For me I really only bought this for my bike, but it turned out to be ideal for many household/office applications.

Very nice product. A LOT nicer then that plastic split loom.Matches the loom on my Holley Terminator X harness almost perfectly so makes my engine way look more clean.Will be buying more.

Good quality product. Installed on my boat to cover up some wires and gas line