onelinkmore MHF4 to SMA M.2 NGFF SMA Female Bulkhead to IPX IPEX RF Pigtail WiFi Antenna Extension Cable for PCI WiFi Card Wireless Router M.2 Cards 0.81mm Pack of 2 (2 inch (5 cm))

Bought these to replace the cheap antennas that come pre-installed on the Orange Pi 5b board. The board connections require a bit of force, but they do fit. Overall very happy and my wifi reception has improved with different antennas.

I needed four of these cables, so I ordered two packs. When they arrived, the packaging was in perfect shape, both the Amazon pack and the individual bags for each pair.One of the connectors was bent at the end. It was a sharp bend, like something sharp had been pressed against the end. It would not allow an SMA connector to mate with it. Since the packaging was not damaged in any way, I can only assume that it happened before it was packaged and it slipped through a quick inspection process.I was able to straighten out the connector enough to use it, using a pair of needle nose pliers under a microscope, so I didn’t bother starting a replacement request.Other than the bent connector, the cables work fine. All of them perform as expected, including the straightened one. I’m sure that getting a bent connector is a rare occurrence, so if you need longer cables like these, they’re probably a safe bet.

The MH4 connection was way smaller than it should be

Even the packaging says U.FL to SMA but these are MHF4 connectors. These are useless to me and set my project back another several days while I wait for a properly labeled set to ship.

... a little cheap compared to others, but will work. Use caution not to cush the ends. 1 would not lock in, like it had been used and stretch out inside and there wasn't enough pressure to keep it on, ended up putting some gurilla tape over it.

Good quality, item as described, good seller!

I can't say that there's anything wrong per se, but it is much thinner than the one I am replacing… other than that it is fine