Graco288488 Contractor & FTx Gun Repair Kit

Worked great no problems

Always purchase authentic Graco parts for your Graco equipment. I made the mistake of buying a knock-off gun rebuild kit prior to this and it leaked after 4 jobs. This kit is an exact fit and I know it will last a long time.

Si le quedaron bien a mis spray guns 👍

Originally when I purchased this & installed it I didn’t take the necessary time to prep the gun. After speaking to a painter who’s been using the same contractor gun for 9 years: I’ve had great success with this part. I cleaned the guts out of the gun this time with lacquer thinner. Rinsed several times. Applied pump lube to the o-rings on the new needle & installed it. The first replacement needle lasted about 60 gallons spraying solvent finishes & latex. After properly installing this most recent needle: I’m over 150 gallons in. First project I used it on required around 40 gallons of shellac & oil.... Just finished a 80 gallon latex exterior project...no spits throughout either job. Quite frankly a clean shot valve is only necessary if you are worried spraying trim/doors/cabinets or are trying to get through a job with a spitting needle.Don’t replace the gun! All you need is this. Oh & the fancy new PC gun is a joke. Stick with the original unless you prefer plastic parts over metal.

Oem graco part, works as it should.

Good product at a good price

Arrived on time fit great haven't used it yet that's why only 4 stars looks a great factory replacement tho.

Be careful with insulation! Press the trigger when installing to avoid accidental scratching of the needle