Fuji Spray5100-5 Aircap Set #5-1.8mm for T-Model Spray Gun

Used it for BM Stix primer and BM Advance paint. Worked very well. Make sure to use ford cup to dilute paint with water (yes you can and should dilute even if it says not to).

It is really difficult to get solvent/oil based finishes in California and spraying Alkyd enamels has been a problem for me. I purchased this tip for use in a gravity fed Fuji T series spray gun using a mite mate 4 HVLP. I was previously using a 1.3 needle but needed to thin with water and flotrol and help the finish level out but with this aircap set I spray alkyd enamelss traight from the can and get a nice wet and even finish. I am by no means a professional but find this combination works great for an ameteur like me.

If you are spraying cabinet doors with latex then this is the tip you need. I has a 2.5 and a 1.3 and neither were getting the job done. It’s pricy but it made my 700$ sprayer actually work.

Sprayed latex primer and paint through this air cap. Very happy with the results.

I painted my cabinets using the Fuji sprayer. I loved how well they turned out. The right tip and the right consistency of paint/varnish are key. Highly recommended for the DIYer!

Worked perfectly for spraying General Finishes Milk Paint thinned with 10% water with my T70 bottom feed gun and Mini Mite 3 setup. Couldn’t ask for anything more.

If your buying this you must already have a FUJI system. I required this cap set for spraying catalyzed lacquer with my T-75 gravity feed gun mini mite. It was a must have for this heavier product. Fuji is one of the best professional consumer grade guns money can buy (other than Apollo).

Superb quality, the Fuji air cap 1.8 is a great addition to the Fuji Q5 turbine sprayer for applying latex paints or other coatings requiring a heavier layer.

Perfect for spraying thicker product.