Hosa CRA-202DJ Stereo Interconnect, Dual RCA to Dual Right-angle RCA with Ground Wire, 6.6 Feet

I used this cable to replace a failed OEM cable on a Pioneer PL-112D turntable. While this is not a high-end expensive cable, the wire and connectors are very good at this price point. I had to cut the right angle connectors off so that I could hardwire the cable to the internal solder terminal strip. The center wire is soft pliable stranded copper. I estimate it to be approximately 22 gauge, which is fine. The shield is also soft stranded copper wire that is wrapped around the center wire. It may not be 100% coverage but it is very close. There is no additional foil/mylar shield. After installing the cable, the turntable was fully quiet with no discernible hum. Overall, this is a great value. I will order more for general purpose audio connections. I do spend more for cables on my primary higher-end component audio system interconnects. If HOSA offered this same wire with higher quality RCA connectors I would not be afraid to spend a little more and use them on my primary systems. Amazon indicated that it would take three weeks to deliver them. I had them it two days! Yea!

Good Product good quality and does the job well. nothing fancy just works and keeps the turntable from humming. I use it on my vintage Marantz 2265 b connected to my vintage pioneer PL-71 with shure v15 IIi it works fine.

These work fine. It's an RCA cable. I have a long cable run from my TT to my Home Theater amp, so I needed the 6 footer. My only gripe is that I wish both ends were straight. The angled connectors are just kind of an annoying fit and interfere with some other cables.

The product on the image was not what was sent, but I feel it meets the criteria they described and I am more than satisfied with the quality of this product, thanks for meeting my expectations. I have been looking for DJ turntable "patch" cables for a long time even guitar center doesn't sell these. I am glad they have them here and they are good quality I recommend these to anyone with an "old school vinyl DJ setup" if needed in replacement of original patch cables. Please continue to make this product it is vary hard to find ps vinyl is making a comeback.

I use these on my old Rotel turntable and haven't had any issues with it. Super clarity connected to my receiver.

The cable connected from my mixer (with built-in Phono pre-amp and grounding post) to my turntable quickly and it has provided clear sound for a few months now. If your set up is similar (most likely if you are a turntable-based DJ), it should go smoothly.

The Hosa 2 meter long audio interconnect cable with ground wire is as expected and seems reasonable well-made. While the Right channel has the traditional Red terminals, the Left channel connectors on this cable are Black instead of the traditional White. It can be used as a Turntable cable with the attached ground wire but is quite a lot longer than is usual for a Turntable Cable. Turntable Cables are usually quite short, a meter or less, so as to keep the cable Capacitance as low as possible. This 2-meter long cable has a measured capacitance of 250 picofarads, which is a bit high for use as a turntable cable. It will work, but might affect sound quality with some combinations of cartridge, tonearm and preamp.

No shielding. You get what you pay for at this price point. The thickness of the cable is all rubber. I cut mine open to verify.

Excellent product, much better then 10x more expensive cables, reduces hum caused by preamp phone stage. Rca connectors could be better but you can always change them yourself just for a more audiophile look. Very happy with the product.

Très bien !

Custo benefício ótimo - entregue antes do prazo.

フォノケーブルにしては安価だったのでショボいケーブルが来るんだろうと思っていたらケーブルも端子も想像より太くて大きかったです。添付した写真の端子はまっすぐですがもう一方はL字型でした。個体差か仕様か不明ですがアース線が微妙に短く、もう少し長ければ取り付けが楽だったろうと思います。

un cable de alta calidad