





🔥 Upgrade your grill game with pro-grade parts and never miss a cookout!
This Direct Store Parts Kit includes 4 stainless steel burners (16 15/16"), 4 heat plates (16 1/8" x 3 1/4"), and 4 ignitors (22" length), designed as direct replacements for multiple KitchenAid 4-burner gas grill models. Engineered for durability and even heat distribution, these parts restore your grill’s original efficiency, enhance flavor by catching drippings, and provide reliable ignition—all at a budget-friendly price.
M**K
Solid replacements.
These installed easy; fit was decent. If they last 3 years; then quite a bargain. The burner screw holes did not align perfectly, so only one screw could be used instead of two, but it was still solid-not an issue. I would buy again. Mark in NY
M**.
No complaints for the price!
They have worked good this summer. I do not expect them to last long, but most of these replacement sets on amazon do not last long.
A**N
Ignitor wires are short
The ignitor wires are too short one out of the four wires would reach correctly. The picture shows two long wires next to one short wire that came with the product.
P**N
Nice looking and fit properly.
After tearing my grill apart, I realize the new burners are not of the same quality as the originals, but do seem good. One recommendation is to include replacement cotter pin, the old ones fell apart when removed. The shields are very nice, but as always ask me after the summer to see if they are still in one piece!
A**S
Awesome
Awesome!!
S**.
cheaply made but works
The stainless steel heat plates are fairly flimsy & thin and you can actually see the glow red when they heat up.The gas burners had to be drilled out so they would fit on the grill as the holes were way to small but they work well enough... you can definitely tell the difference in build quality from the original ones for the kitchen-aide grill.if you are aren't afraid to use a drill and have a little aptitude with power tools you can make these work.
L**Z
Amazon to the rescue -- again!!
Fit perfectly and was affordable -- unlike others available online. Used to replace old and worn grill parts. This came in a kit -- four deflectors PLUS four gas tubes -- all under $30 -- total. Other experience was price for single deflector alone $40 - $60. Thank you Amazon for looking out for the average person's needs.
J**Y
NOT a direct fit
These are very nice looking and well built but are NOT a direct fit.1. The screw hole patterns for the ignitors do not line up at all and thus I ended up using only 1 screw in each ignitor.2. The 'gas' holes along the burners are in a complete different pattern and do not get nearly as hot as my old, original set.3. They are hard to light and constantly 'cycle' with the burners going out momentarily...whump whump whump constantly. Reinstalled my old burners and they are fine. Swapped back and whump whump....even went and topped off my tank just to make sure, no difference.4. Due to the above issues it takes much longer to grill anything and steaks thicker than 1/2 to 3/4 of an inch will never cook all the way through. The outsides will dry out and the inside will still be pink and sometimes bloody. It is also impossible to sear the outsides of a steak. Thin steaks and burgers only.5. With my old burners when I was through cooking I could leave the grill on a few minutes and any grease/gunk left on the grill would burn off and turn to ash, easy to wire brush away. Not so with these burners as, again, they just do not get hot enough. You will always be left with a greasy mess that will never burn off.TL;DRNOT a direct replacement, hole's don't line up, doesn't get nearly hot enough to cook anything past burgers or thin steaks.The heat shields are very nice though.
Trustpilot
1 day ago
3 weeks ago