FASS Fuel Air Separation System Titanium-Series 95gph 06-10 Chevy & GMC Duramax 6.6L Diesel - T C10 095G -

As another commenter had said, the instructions are vague at some places. Some things I saw specific to my 2008 duramax - the suction line is above the front of the tank, and is rubber hose towards the passenger side (tank side) and metal on the engine side. The clip fitting on it doesn't need a special tool to unlock, it just has a red clip you push from behind forward to disconnect it. The instructions say mount it to the first bed bolt, but because of the routing of the filler hose, this will make it stick about 4-6 inches below the fender. I mounted it to the second bed bolt, and was able to get it up to where it is barely seen. The bracket mounted this way does stick out and might get hit by the tire if it bottoms out. Also my Duramax had a separate return line that was 1/2 inch. I tapped into this using a 3/4 pex tee (only tee I could find at Home Depot that would fit). Be sure to look at the diesel wiring schematic, as the owner's manual will steer you to the wrong tap point. Also be very cautious tightening the downstream side line to the AN fitting. It is located right above the aluminum fitting for the return line. It can be easily nicked with a wrench when tightening it Overall very pleased with its performance so far, and now I can ignore that stupid worthless priming pump that it came with!

Install went per instructions, and the only hiccup for me was the rust around the fuel line disconnects over the years that accumulated making it take longer to get the lines separated.The filters shown in the ad are not the same ones,they have been updated to filters that do not have water drain cocks. I also added the bottom tank sump kit fuel line pick up from Ohio Diesel Parts ,FSK-1500-A, I felt they had a better securing setup with the use of 3 bolts instead of 1.

Fairly easy to install although the instructions could be a little bit more specific for the application. Had it been more clear, I would have routed fuel lines differently. Worked great after only a few seconds of priming. I haven't driven with it much but hope it will do as promised and keep my injectors running longer than without it.

Excelente

Received it installed it works good