Nutri Set of 3 Gaskets with Lip, Fits Nutribullet Blenders

I purchased these to replace the gasket on my Nutribullet Pro (900W). The description stated they will fit. However the gaskets I received were too large and they did NOT have a lip. I read through the reviews again and decided to try boiling one to see if it would shrink but the size remained the same and the gasket still would not fit. At least I paid less than three dollars for this. Gave one star because I received the item within the time frame promised.

The items in the photo clearly show gaskets with the lip and the product even says that in the title, however the gaskets I received have NO lip and consequently don't fit the chopper base or the cup caps. If these had the lip inside they would likely be a good fit. Looking through the reviews I see others have had the same problem. Don't wait a month for delivery and then find out these don't fit your Nutribullet either. Opt for the manufacturers product, even if it costs a little more, but at least you'll know you're getting the right part.

Finally tried to replace original gasket with one of these I had ordered last year. They are too small. Found a youtube video entitled "Nutribullet Gasket Installation" that even says "a lot of people think the gasket is to small" then it goes on to supposedly show how to use "all of your fingers" plus thumb to install. After 45 plus minutes couldn't stretch enough to install just ended up with a cut on my hand from the blades. No one should have to go through all this to try & install a simple gasket

I agree with other reviews that these are hard to put on and to remove to wash, but they do work! And the cost is much less than the original. Like the instructions state, you can put them in hot water to soften them for easier installation. I have small hands, and it still took me a little time to get it on. If you have large hands, you may experience more frustration.

I have heated this gasket in hot water, in hot water in microwave, over a bottle in the sun and still unable to get in into the bottom on my blade. You need 3 sets of hand to do it all holding down the gasket. I still have not been able to get it in.

I am extremely disappointed. I purchased these to replace the gasket on my Nutribullet. The description stated they would fit. However the gaskets I received were too large and they did NOT have a lip as was pictured. I tried boiling one as recommended in the reviews, however, it still did not fit. This is not at all as was advertised and I am extremely disappointed in the product.

I was skeptical when reading some of the negative reviews, but I took a chance. The gaskets fit perfectly. They are easy to install with no special tools required, just two fingers and that it. Don’t let the neg reviews frighten you, they are spot on perfect.

The washers themselves seem slightly smaller than the originals and pop off from time to time...while they are on, the unit is sealed and there are no leaks. They do come off easily to wash. A 3 pack is great for keeping me mixing for a few years.