TRD Grille Decor Badge, 3-Color Upgrade Emblem, Grille Insert Trims, Tri-Color Grille Badge Emblem Car Decoration Accessories Fit for Tacoma 4Runner Tundra Sequoia Rav4 Highlander (Yellow Orange Red)

This tri-color TRD-style grille badge is a small but great-looking mod for any Toyota truck or SUV. The colors are vibrant, the plastic feels solid, and the mounting hardware is strong enough to stay secure even on highway drives. Installation takes only a couple of minutes — you just thread the bolts behind the grille and tighten them. Once mounted, it doesn’t rattle or shift. On my 4Runner grille, it sits perfectly straight and adds a subtle but sharp accent without overdoing it. For a cheap and easy exterior upgrade, this badge gives your front end a more customized look with almost zero effort. ⭐ Pros & Cons Pros: ✔️ Vibrant color finish ✔️ Solid mounting hardware ✔️ Easy 2-minute installation ✔️ Works on many Toyota models ✔️ Clean TRD-style accent Cons: ❌ May not fit grilles with thick mesh ❌ Can fade slightly after long-term sun exposure

Very nice and a great way to show Ameeican proud.

It’s cheap when a screwed in the screw. It popped out the sticker. The nuts don’t fit on the screw and the screws are super long for no reason will never buy this again.

Fun, easy product to support Toyota’s heritage.

This is a good product at a very fair price when I purchased. However, within a year the colors have faded and the red is more of a pale red/pink and the others have faded as well. I purchased 2 so I will swap the new one for the faded one. Other than the fading it's a cool look for the grill of a TRD Tacoma.

ATTENTION!!! Before purchase just know for those who have 4th Gen Tacomas you will NOT be able to access the lower middle of the grill due to it being blocked off from inside! This was added in to a 2025 TRD Sport 4x4. The process was simple and takes a couple minutes. You will have to drill two holes properly and carefully aligned for a perfect hassle free fit! (SEE PICS) if you noticed I marked with a sharpie where the alignment of the badge threads are located and then carefully eyed the center. Once you feel the alignment is good then proceed to drill slowly and accurately two holes. If you notice from the provided pics I didn’t hit any obstructions when drilling through. I purposely placed the badge more to the left so as not to hit anything and have plenty of room for the nuts. Also, you can see I decided to add two plastic spacers behind the badge for a solid non rattling fit. I also added to plastic washers in the back too and applied the nuts. I used ONLY the socket itself to hand tighten the nuts because the socket only allows you to slide over the long screws with no problem. It’s now a secure fit and if need be can always be replaced whenever. Four stars because there’s no back plating on the badge when applying the screws behind and this caused one of the color plates to come undone. Other than it’s pretty nice!

Good product!

Buena calidad