Silverstorm 269222 Table Saw, 254 mm, 1600 W

very disappointed with this sale as it was listed as new but on arrivalit soon became clear it had been opened previously by someone else.there had been some assembly and may i say incorrectly. the paintworkhad a number of scrapes and some of the parts were not even in theirpackaging ie lying on top instead of inside the bags.half the screws and nutsfor bolting together were scattered inside the box and not in bag provided.apart from this the saw is a good saw and performs well.

Cutting guide on this saw is useless when you tighten the guide it pulls to one side leaven you with an angle cut when you should have a straight cut had to modify the guide to get it to cut straight once done the saw was OK could have done with better packageing as one of the corners was damaged this only gets 3 stars because of this as the the guide is very important

although little fiddly to put together otherwise an awesome piece of kit

the stand needs to be sturdier

Very sharp edges to top and you have to turn it upside down and remove the bottom to change the blade.

Not bad for the price. Wish I could afford a better one!

It would have got 5 stars but the quality control in the build leaves something to be desired. The base was bolted to the top all twisted and although the blade lined up the legs would have been hard to fit and would not have sat flat so I had to loosen the nuts and realign it square. I had a surplus of spanners and nuts but not enough washers and bolts. I had my own spare source so it wasn't a problem as such to me. The price of the saw more than compensated for the inconvenience though. At a third to 75% the cost of my old metal cutting table saw, this has turned out to be a bargain. I fitted an Evolution metal cutting blade and it performs perfectly. The guides sit surprisingly square and allow a true cut without having to be reset. All other saws of various makes have given problems. The instructions for the legs could be better as it is trial and error to get the right part to each corner. Overall I would buy another one should the need arise

i purchased this table saw last year because i needed a table saw, so bought this table saw first the fence was touching against the runner slots.so i had to make the top base and a fence. when i raise the saw blade up the angle adjusting knob moves and i don't get 90 degree cut.when you lower the blade to the very end and as i raise it up the adjusting height blade knob become stiff and tilt the blade.