Carwires PT40-4-AWG Crimp Power Terminals (8-Pack)

I used these for my 4 gauge wire to my amplifiers. They are fine, except the spade part is a little bit short and seem to work them self loose from the terminal if jostled a little bit.I soldered my wire into them and followed that up with wire loom and heat shrink. They do look nice, but they could have a slightly longer fork.

The connection are not wide enough to fit on the screw terminals.

A bit expensive for what they are, but these size terminals seem to be this much or more everywhere. The product is well made, had to break out some tin sheers to open the package however, are thick plastic and METAL rivets for the package really necessary? Function is as expected, good sized crimp area, others I have bought had a very small crimp, often resulting in the wire coming lose, I however solder all of mine, but the larger crimp area is still nice. The rubber sleeves are a nice touch, though heat shrink is cheap, looks better and tends to keep out moisture, and would have been preferred for the cost, I keep large amounts on hand so that's no issue to swap out. Over all, for its use, if I needed more I would order again.

Good product

These were perfect for my car amp installation and can't be found in many local stores any more.

Worked just as advertised thanks for the great product at a great cost

Arrived as described and shipped fast. Used for hooking up power and ground wires to a small audio amplifier in my golf cart.

Good product, good pricepoint, but fragile. It will hold under a #10 screw, but if you need to add multiples of the product, they snap 1 leg off even when properly tightened, oiled/protected, and soldered, not crimped. I examined them further and noticed that they are weakest at the point the fork terminals connect to the 4AWG terminal housing. For most jobs these will work, but for anything with heat and any kind of vibration you will need to add 10 more dollars for a higher quality metal product. 4AWG terminals are not a common thing, so I can't doc the product to much, but it didn't work for my application. (Fusebock with 10-24 screws)