WESAPPINC Rubber Foot Strip Replacment for HP Envy x360 15-DS 15M-DS Series Laptop Bottom case Rubber Foot Strip (Grey) (Grey)

Works great for me easy to install good quality

The strips are about .5” short to perfectly fit on my laptop so the screws are showing on the bottom but it’s a good quality strip. Easy installation.

Exactly what was needed to match the HP laptop feet.

So first off, it doesn't quite fit. The size is just plain off. Fortunately, it's smaller than it should be so I can still put it in. However, one side is plainly fatter than the other so while one end slots in fine enough the other end doesn't and so protrudes outwards.It's easy enough to install though and seems to stick fine enough (so far, at least). Not something I'd buy ever again though since the manufacturing tolerances are obviously really bad. Should've been pretty obvious from the moment I saw the plastic the strips were on since whoever cut the plastic couldn't even bother to cut a straight line.

Thicker and heavier than original, and better adhesion.

These always tear when they're a few years old and/or someone didn't take care when opening up the laptop or was missing the right tools. So it's good to get a pair of these if you're opening the laptop anyway and they're broken, missing, ugly or you don't want to worry about tearing them when removing the bottom. If I remember, the length was pretty close to what it should be, and the color was good too, so go ahead and get them.

It’s just been over 3 months I bought this product. The rubber strip for the laptop feet doesn't stick well and frequently comes off. I'd recommend looking for a more durable alternative.

These are too large for an HP Envy/Spectre 360. After trying to place them into the area for the feet, I found that they were too wide and sit crooked. 6mm width is incorrect, the slot width is 5mm. I would not recommend these for the HP Envy/Spectre 360. I should have measured the slot width before purchasing.