1.25" (3.18 cm) Sorbothane Hemisphere Rubber Bumper Non-Skid Feet with Adhesive 50 Durometer - 8-Pack

These things are really good! For my Tannoy Little Red speakers (by no means little), I've been using granite cutting boards placed on thick open-cell foam and that worked very well. However I swapped the Reds for the larger, heavier Tannoy Cheviots and they were too much. The bass was booming from the cupboards they were placed on. So I took a punt and bought theses sorbathene things. They work brilliantly! 4 under each speaker, straight onto the cupboards, and almost no vibration is transmitted. Bass is now tight and strong and the whole sonic image is focused. 22 pounds VERY well spent. Totally recommended!!!

I have just bought my first packet of these, and am very pleased with the result. I have used platforms with a sorbothane component in the feet before, but I have never tried these handy stick-on attachments. In a headphone set-up, I added them first to the source (Oppo 103) where I noticed a marked improvement in clarity and detail, with an enhanced musicality. I then tried them on the headphone amp itself with similar, but less discernible, results. For £20, this is a terrific enhancement. I am telling myself that they can't possible help the DAC (but you never know until you try).

Bought these to replace the old squash balls thar I've been using for years to isolate my hi-fi kit on the rack. These are much better! The slight buzz from the Azur 640H (I could only hear it when everything else was turned off) was cured completely.They have a slightly sticky feel. It is difficult to get excited about something like this, but they do the job and aren't obtrusive.

Got 2 Mackie 824HR MK1's on 30mm solid Iron desk stands, I was getting some vibration coming through on the desk at around 150hz which was especially noticeable with kicks drums and bass, through it give these a try and they have done a very good job at stopping the resonance, bit pricey but should last a lifetime. Also arrived next day which wasn't expected.

I bought these to dampen any vibrations in/from my media centre. I have bought a lot of sorbothane products over the years and often you are short changed by the actual amount you get for your money. Here that is not the case; the feet are substantial and make a big difference when used.

Used between bookshelf speaker and glass shelf... The bass became thinner, and after 3 months, two of them seem to be leaking a bit? Not everywhere, just a bit oozy on the bottom. The speaker is quite light... so not good.

Excellent sorbothane isolation feet. The self-adhesive surface has proved to be very effective.. These feet are ideal whenever you need to isolate an item from surface-borne vibration, particularly within the audible spectrum.

Works great under speakers. Much better isolation of Low Frequencies.

Conosco il sorbothane da quando avevo il giradischi Oracle 3a serie, di questo materiale era fatto il tappetino sul quale appoggia il disco.Questi piedini sono ottimi per isolare dalle vibrazioni gli apparecchi HI-FI in quanto assorbono le vibrazioni e le neutralizzano, trasformandole in calore. L’eliminazione delle vibrazioni funziona a doppio senso, cioè vengono assorbite anche quelle generate dall’apparecchio.Una accortezza da avere sta nella scelta accurata della dimensione dei piedini in base al numero di questi che si decide di usare.1) non è obbligatorio usare i soliti 4 piedini, in base al tipo di apparecchio ne possono bastare 3 (se piccolo) o 5 e più se è largo ed ha una superficie estesa. Ad esempio, nel caso si vogliano mettere sotto un giracd, un convertitore o qualsiasi altro apparecchio con la base inferiore larga, potrebbe essere utile posizionare 4 piedini ai lati e 1 o più al centro tra piano di appoggio ed apparecchiatura. Fate attenzione alla conformazione dell'apparecchio.2) controllate bene il range di peso consigliato dal costruttore. Prendete il peso dell'apparecchio e dividetelo per il numero di piedini che pensate sia utile utilizzare. Poi scegliete la dimensione di piedini che ricadano circa nel mezzo del range consigliato.3) I piedini sono autoadesivi, quindi prima di applicarli definitivamente fate delle prove senza staccarne la pellicola protettiva dell'adesivo.Un pò di tempo perso a tavolino vi farà fare la scelta giusta che vi gratificherà con ascolti migliori.

Yo las he comprado para darles este uso. Los bafles pesan unos 13 Kg. y he usado 4 esferas para cada uno. Llevan poco tiempo de uso pero hasta el dia de hoy el material se comporta perfectamente. Quedan bastante chafadas, pero no van a más, estan igual que el primer dia. Aislan las vibraciones casi al 100 % y he notado mucha mejora en el sonido. El único problema que les encuentro es que son bastante caras.

Ich kann die Produkte von ISOLATE IT nur empfehlen. Als High Ender verwende ich die Füsse unter fast allen Hifi-Geräten, natürlich dem Gewicht entsprechend. Die Teile bringen Ruhe ins Klangbild, vorallem Bassläufe werden deutlich strukturierter. Der Preis für das Tuning ist nicht so abgehoben wie andere Produkte.

Used these under my JBL LSR305 monitor speakers on a glass table and actually had a genuine jaw dropping moment. Obviously a glass table is not ideal for monitoring however that's my only option right now and after experiencing these I will be using them on whatever surface my monitors sit on, stands included to achieve proper frequency levels for mixing, recording and producing.Test 1: Speakers only on glass table. Used palms and fingers to feel the area next to the speakers and under the table where the speakers sit. Results : Clear, obvious and strong vibration/humming of all low frequencies resulting in a false sense of bass throughout the table. Used Britney Spears' "I Wanna Go" as the reference song as it has strong bass frequencies from start to finish.Test 2: Placed 4 of these under each speaker (round side up supporting speakers) still sitting on the glass table. (Did not remove adhesive on flat side) Results : I kid you not, a 90-100% reduction of the same exact false low frequencies at 90+db. I'm in disbelief that these little black crescent shaped squishy "bumpers" could absorb and dissipate that much bass before it reached whatever surface the speakers would sit on.Test 3: Set my JBL LSR305's on these bumpers again (round side up adhesive peel away still intact) which in turn fit perfectly on each point/leg of my ISO Acoustic L8R155 speaker stands. Results: 100% reduction of any humming, buzzing or vibration of bass frequencies traveling through the table.You can normally feel the bass traveling through the ISO Acoustics however it's severely reduced when the speakers have these bumpers in between them and the stands resting points.Conclusion : I can't believe this material isn't used in every monitor stand or promoted more as a decoupling method for speakers. I'm not sure how the one reviewer here did not experience these results. I tried Blue-Stick (Tack) and the results didn't come close to this. Incredible and well worth the $20+. While I also recommend the ISOAcoustics as they give your monitors a much needed lift to ear height and an apparent 80-85% bass reduction which greatly improves and tightens bass response and boosts the clarity of the mid and high range, I wouldn't hesitate to place my monitors on these bumpers alone, which cost a 5th of the price of the ISOAcoustics and in my opinion decouple and dissipate/absorb low misleading bass frequencies much better. However the ISOAcoustics give an unmatched floating/raised height effect which is extremely beneficial. The reaction I had the first time listening after placing my speakers on the ISOAcoustics is subtle compared to the reaction these sorbothane bumpers gave me. If the ISOAcoustics are out of your price range these bumpers placed on a regular or DIY stand would have the same decoupling effect.Note: I have not peeled the adhesive off of the underside because I'm hesitant to have adhesive glue stick to the ISOAcoustics resting points but I can only imagine the decoupling effect would be even greater if the 3M paper peel (reflective material?) was removed. It also might not make a difference as it is extremely thin.That said, combining both the Sorbothane bumpers with the ISOAcoustics L8R155 like I have gives an incredible kind of mind blowing result with more credit going to these bumpers than the stands. Extremely satisfied.

Lo utilizo para mejorar rendimiento de Altavoces..Tenia los altavoces encima de un mueble de television, estos son unos Bose 301 Serie V. La vibracion retumbaba sobre el mueble generando una molesta reververacion acustica.Con estas patas la vibracion ha desaparecido casi por completo... Y la mejora de audio ha sido espectacular... POR FIN PUEDO DISFRUTAR DE MI EQUIPO DE MUSICA !!!!!!!!!!!!!!!