KitchenCraft Meat Mincer in Gift Box, Home Made No. 8, Manual Mincer, Cast Iron, 28 x 24 x 9cm, Silver

I already have an electric mincer 75kg per hour and 8kg stuffer and used to make a lot of sausages on a regular basis. Now with just two of us at home and i no longer make and sell large quantaties decided to buy a smaller unit. Firstly i dried a white baguette and using the smallest bore mincer plate made the bread crumbs which were a good consistancy, i then put the pork through the largest bore mincer plate i then mixed in the herbs, salt, pepper and sundried tomatoes in olive oil ( in a bowl) and pushed it through the middle bore plate to give an even mix. Finaly i took out the cutter and mincer plate attached the sausage maker attachment pushed the mix through into the skins job done in about two hours including clean up.Sounds easy and it is with a bit of practice just a couple of tips real important you MUST set the cutter against the mincer plate before you start mincing, turn the handle you will hear them touching it is then set properly, the other way is to screw the securing ring as tight as you can by hand and turn the handle it will be hard or impossible to turn the handle then just slacken off the securing ring until you can turn the handle comfortably it should be about right then.If the meat comes through as mush or not at all clean and reset as the cutter and plates are to far apart. Don't rush the job and it all falls into place i hope this helps. I made about 4lbs this time excellent for home use.

ABSOLUTELY AWFUL.Dont bother purchasing this. Its an overpriced, poorly crafted piece of scrap iron.I bought this thinking it would be a stronger product than a plastic one. Yes it looks strong and heavy, but thats because its made from UNTREATED CAST IRON. It will rust if you dont apply vegetable oil all over it, making the mincer horrible to handle.It stains your food grey, it makes it stink of iron. I mean proper reek. Even the dog wouldnt eat the food (Not that i would have let him)The cutting blade started splintering and breaking up after the first wash, so we were finding sharp metal in the meat.I will be demanding a refund, and will purchase a plastic one to avoid any of my food smelling like metal. Trash.

I was not happy with this item. It should be stated in the selling description that it is a ‘big’ mincer. When you view the box it states it is big and when you unpack it yes it is big, not a die that you would use or store generally in your kitchen. The item works well and is solid and fits to the table well but too big for me to handle and use.

good quality value for the money

Poor quality casting for the body,only use mine for the bird nuts,don’t think I could recommend for human food as your hands go black when handling .

It arrived in good time and I am satisfied, I recommend the customer to everyone.

I was looking forward to using this product. When it arrived, it was constructed of typically cheap and rough-cast iron and I gave it a good wash to remove all residual manufacturing grease before assembling. When installing the cranking handle, there is a flat edge to the round spindle, that lines up with a flat edge on the cranking handle. This is held in place by thumb screw with a paper thin washer. I installed the handle correctly and tightened, but when cranking the grinder, the handle would rotate on the spindle and not stay locked in place. It was physically impossible to tighten the thumb screw any tighter than I had, and therefore, with a handle rotating and the spindle/worm screw, barely rotating, the product did not work. Rather disappointing.

This is what we needed long time

Excellent rapport qualité / prix, un indispensable quand on doit faire des préparations dont le haché ne doit pas être trop fin !

Lo compramos para mi padre que le encanta hacer chorizos..y le va genial..por poner un pero las cuchillas vienen con poco filo

Top, genau wie ich ihn mir vorgestellt habe. Schnelle Lieferung

Prodotto molto affidabile, che svolge molto bene il lavoro per cui l'ho acquistato. Lo consiglio a chi vuole un prodotto valido senza spendere troppo.

Garbage. Brand new and doesn’t work. Tried mincing chuck and brisket for burgers with the 10mm plate, thread sheared off the front attachment and blade and plate wouldn’t cut through the sinue and would block and tangle. Cheap build with blunt blades, total waist of money. It’s basically an ornament.