Rolson 30339 9 pc 150 mm Screwdriver Bit Set

So far so good and worth it

OK FOR WHAT YOU GET,NOT VERY GOOD QUAILTY BUT LASTED FOR 4 MONTHS AND CONSIDERING IT WAS CHEAP IT IS OK

As described ideal for drill use. Happy with purchase

Purchased for screwing in pocket joints where the old bits would get stick or fowl on the edges. I wanted really just pz2 but found it was cheaper to buy multiple bits rather than one or two. They appear good quality and I’ve used this brand before so didn’t expect any issues with build quality. Like any driver bit you need to use the right one for the right job else they will burr and break cos they will not fit correctly and slip, if the screwdriver speed is too high or you are not square to the screw the same will happen. So do the job right with the right tools and you won’t have a problem, as I see it no one should have to write a review with regards to quality and wear if they are sensible in how they work.

These 150mm bits are excellent for use in spaces where the drill is just too bulky to get close enough. I used these on a two projects where a couple of them had a great workout. The only slight criticism would be that they are not 100% straight. With a very slight wobble. That did not impact on their use. They performed admirably and finished the job. I did manage to round one of the bits but that was my fault I forgot to change it over with the correct screw. My bad. Great little set handy to keep in the garage. Will use often and for the very cost conscious were a bit of a bargain

For run of the mill work these were ok but when I starts driving 90mm screws into framing with an impact driver the ends broke up as you tightened the screws down. Have had other brands that seemed tougher and problem only occurred with the impact driver

Great value thanks

Perfect just what I needed.