Blue Spot 19022 Diamond Burr Set (30 Pieces)

There so good! Very precise and well worth the money.

Ok

Does what it says, nice set of bits that I use for engraving. They have worked fine without and signs of stress so far, and the variation is nice even if I don't think I shall use them all. They meet my needs and I have no issues

I was dubious about the quality for such a low price, but this is a really nice engraving set. I have used them to engrave soft wood, brick and indian stone (very hard stone). All with ease and they all look great. Highly recommended.

as described and fit for job

I wanted to have a play with engraving using my Dremel... well what else can I do in lockdown, it was a budget priced set but the bits do the job quite well. Maybe if I get proficient I will buy a more expensive or professional set but these are fine for what I’m doing at the moment.

Unusual shaft size so dont fit standard dremel collar

Really good value for money. Last about as long as you would expect for the price. Not as good as the considerably more expensive ones but are much cheaper so it's swings and roundabouts. These are great as an introduction to glass etching and to figure out which tools are the best for you. There will probably be loads of ends that you never use though. All in all these are great and I always have a new set in my arsenal.

Lo uso para perfilar y limar restos de soportes de impresión 3d en PLA, todavía no lo he probado con figuras de resina pero por ahora estoy muy satisfecha

Prix bas, mais bonne qualité et solidité pour l'usage prévu (gravure de pierre dures)Le même diamètre de queue de toutes les fraises facilite les mise en place (pas besoin de changer de mandrin)

Le produit est arrivé bien emballé mais avec des meches tordu, j'ai tout de même voulu percer une pierre avec les meches mais le revetement diamentée ne tient absolument, sans appuyer, les fraises deviennent lisse.Impossible de percer avec ca.Je trouve décevant d'acheter un produit pour le jeter dès sa reception.

No he podido probarla con diferntes materiales y ademas la verdad no tengo demasiada esperiencia con fresas es la primera vez que las compro, pero dare mi opinión repito desde mi ignorancia en estos articulos.La he usado para fresar madera y bien aunque lo he hecho de una manera muy lenta y con una maquina cnc de fabricacion casera y las fresas bueno las veo que soportan bien al cortar.En un error mio le di al botoncito dichoso y sin controlar la velocidad, supongo le exigi demasiado por que se me trabo la maquina y la fresa partio, como repito estoy aprendiendo sera normal, mi calificacion es de que al menos para uso en madera creo cumple bien.

estupenda colección de herramientas de bricolaje