Waterproof Brass Underwater Light Fixture for Patio, Pond, Fountain, Waterfall - 2 Pack

Very bright and extremely waterproof. First one I purchased is constantly in the water under a fountain and it has been working for 2 years with no problems.

This is best underwater spotlight i've purchased. Before this I used the plastic lights which inevitably leak.This unit made of high quality materials (solid brass) and looks great. It is bright and i've had for a month and no issues. I bought a second one for my other fountain. It comes with led bulb and waterproof connector nuts which makes this a good value. Only concern I have is I read in another view company will only provide replacement gasket only if you purchased from them directly. Crossing fingers that this light lasts a few years as changing lights in a fountain is not a pleasant project I want to repeat.

I purchased one for my Koi pond to replace old broken plastic underwater pond lights. This light is much brighter than any of those and it is much heavier so that it stays where I place it without being disturbed by my fish and floating out of position or to the top. I liked it so much that I purchased a second one for the pond.Putting the included bulb into the holder is a little difficult as there is not much room and your hands get in the way of being able to see to align the bulb pins in the holes. If you take your time you can do it and then carefully push the pins all the way into the holes.Then you need to align the front cover with the glass and the gasket and tighten the screws down securely. I think those that have mentioned leaks may not have tightened it enough. I have not had any leaks in either light at this time.The two lights provide more light at night than the 6 plastic ones I used to have.I did buy a low voltage transformer as the lights do not have a plug on the end. They have bare wires that have to be directly connected to the low voltage transformer.I hope they last as I am very satisfied with them at this point.

The light works fine. If you want to use it underwater, eventually the rubber seal will give way (past experience) and then you'll want to replace the seal and light. There was no bulb serial number on the light and no obvious way to get a new seal if needed. After three years of use, I had to throw my last set into the recycling because there was no way to get the seal to repair it as far as I can tell. If I knew, I'd order the seal now so I have it available next time I need it. Other than that - the light works well underwater and I'd buy it again.

Installed underwater in a concrete fountain. A few months in, these things are working flawlessly. No problems with water leaks. Bright, beautiful soft white illumination. Set on timer on at dusk, off 6 hours later. Made of solid brass and weighty af, this is a quality product that does exactly what it’s supposed to. Yes they’re pricey, but I was hoping to spend the money once and so far these lights have delivered.

Unfortunately, this one falls in the category of lights that will fail within a short period of time. Looks good and appears to be heavy duty. But, not for underwater use.

I love the light.I put it at the 7ft deep end of my rec pond. It works great. The only thing I disliked about it was the warm light bulb it came with. I changed it with a daylight light bulb.

Needed a good LED light fixture for my backyard water feature/waterfalls and after wasting money on a cheap plastic gang of four lights which failed miserably, I was very pleased when I received this brass fixture and felt the weight of it and the well finished materials. The lens has a THICK silicone gasket to seal it and standard MR16 LED bulb fits. A bit tricky to plug the MR16 in with fat fingers but the bulb is in place I doubt it will go anywhere.The cast a fairly wide path of light and illuminates my pond and waterfall very well, even casting light on the shrubbery and trees behind the waterfall. I am very pleased with this MIK Solutions Underwater light and look forward to a long life of use. If anyone knows where I can purchase an aqua or turquoise colored MR16 bulb please let me know. I settled on "blue" but I would really like to see aqua or turquoise colored pond and waterfalls. Oh, the cable supplied is impressively thick and should hold up well outdoors.