Get the organization of the pws4105tx 41" deluxe extreme portable workstation with the mobility of the pws4124rctx 41” roller cabinet in one great Combo! deluxe pws: 41.5” w x 23.625” D x 23.25” H •16 gauge steel construction with Welded seams •power tool Rack with built-in power strip •pull-out side shelf and side drawer with built-in power strip •drawers and shelf use ball-bearing slides rated 100lbs/pair •storage Trays built into drawer fronts •weather stripping creates seal against dust/moisture includes: • 23 combination wrench Pegs • 49 screwdriver/ratchet driver/extension holders • (48) 1/4” deep/shallow socket Pegs • (32) 3/8” deep/shallow metric socket Pegs • (22) 3/8” deep/shallow SAE socket Pegs • (32) 1/2” deep/shallow socket Pegs • (22) specialty tool socket Pegs • (13) wide specialty tool slots • 29 piece drill bit holder • 6 slot pliers Rack • roller cabinet: 41-1/2”w x 24”d x 41-1/2”h • self-latching, full-width aluminum drawer pulls • drawers use ball bearing slides rated 100lbs/set of slides • EVA foam drawer liners included
D**O
So far so good. Love the slanted top section.
So far so good. I bought this (the whole upper and lower unit) about 6 months ago I think. I haven't rolled it around much yet, but i already have a lot of tools in it (just about all the tools I own). I love the organization of it. I bought this box specifically because this is the only toolbox I've seen with the slanted upper and that's exactly what i wanted. Montezuma has one too, but I honestly think this is the Montezuma just rebranded. I don't have the ridiculous amount of money for Mac, Matco or Snap-On, but this one seems pretty well built. I read reviews on it before purchasing it and one person said they were rolling and it wasn't nearly loaded to the capacity it says it can hold and the caster/wheel bashed in a bit on the bottom and now it's at a bad lean. Because I read that, I still ordered the tool box but I bought some 1/4" thick cold rolled steel plate (4" wide) and cut two pieces to the length of the width of the box itself. I drilled holes in the plates so the caster bolts could go through and mounted these two plates wide-ways between the casters and the bottom of the box. I really feel like this buckling issue the other guy experienced will not happen to me, lol. Otherwise this seems like it will continue to be a very nice toolbox. The drawers slide well on the bearings and I like the autolocking feature of each individual drawer. You just lift the handle as you pull the drawer out, and when you close it, you hear it latch again.
Trustpilot
2 months ago
2 weeks ago
