RV or Trailer Roof Vent - Manual 14" x 14"

I installed two Maxx fans in my rig three years ago in the winter of 2017. I live in my rig, and have spent most of my time in hot places like Florida and New Mexico during the summer, so I basically ran those fans constantly for three years. They did an excellent job, but like anything mechanical, they have a point of failure. It turns out that that point is at about 1000 days of constant use for a Maxx fan. The first one died on me last fall, the second one kicked out a few months later, in early December.I replaced the first one with a new Maxx fan, the 7500K Deluxe with Remote. I got it on Amazon for $230. It's a great fan. It's quiet, it draws a lot of air through the rig. I always run it on exhaust, and the specs say it pulls 900 cubic feet per minute at full speed. Seeing as I have only about 1000 cubit feet in my rig, that means that that one fan replaces the air in my rig roughly once in a minute. Two fans running at full speed create a wonderful vacuum pulling air like Charybdis sucks sea water.When I had both of my older Maxx fans drawing air, I'd close everything up except one or two strategic windows, and would get a pretty powerful breeze through the limited openings, currents of cool fresh air equivalent to the force of a fan. Very nice on hot days when coupled with a couple actual floor fans. When boondocking without shore power, it makes for a nice substitute for air conditioning.An air conditioner can pull over 30 amps, two Maxx ceiling fans and one or two high powered shop blower floor fans draw maybe at worst 2 amps, max. You can run several fans for 24 hours and use fewer amp hours than an air conditioner might pull in one hour.When my second fan died, I went shopping. The Maxx 7500 here on Amazon was running at $380 - way too much. I saw this, and the good reviews convinced me to give it a try. About a third of the price, this. Nice.I just installed it today. It's not bad. It has three exhaust settings, and two intake speeds. They claim it pulls at high speed 950, at medium speed 650, and at low speed 470 cubic feet per minute. About the same as the Maxx, but this has a dial setting, where the Maxx has has a push button spectrum to increase or decrease speed with more nuance. One major drawback over the Maxx is that on high exhaust speed this fan makes more noise. Maybe twice as much. Not so much to be really annoying, but more than I like. The medium and low settings are *much* quieter, completely acceptable.There's no remote with this new fan, which for me is not a problem, because I never use the Maxx fan's remote anyway. I'm 6' 2" and the fan controls are roughly 7' off the floor, which is no problem for me to reach. But the person I had giving me a hand with the installation is 5' 6" and she can't reach the dial.. So be aware of that potential problem.There is also no moisture sensor on this, and the lid is opened and shut manually. This is potentially problematic, because rain could be dangerous to the fan.. If you aren't on top of things, paying attention and closing the lid when it rains, water could get in the rig, or even destroy the fan. The upside is that there is no motor or sensor to break down on you. My second Maxx fan's lid motor started to fritz out on me at the very end, making an annoying clicking sound when it operated.I'm probably going to attach the Maxx vent hood that I had on the old fan, to keep the rain out. There are no hood attachment points on this like there were on my last Maxx (the more expensive Maxx fans are designed with clip points to attach lids, or like my new 7500 have a rain guard grill already installed), but I'm going to jerry rig a solution to securely attach and repurpose the old Maxx hood.The lid on this is tinted, but not as dark as the Maxx fan smoke lid. It lets in quite a bit of light, which is very nice.. Covering it with an external lid will eliminate that light, which is sub optimal.. But preventing any rain from getting on the fan or in the rig is a more important priority.Over all I'm pretty pleased. This fan in tandem with my second Maxx are pulling air like champs. On the medium exhaust setting it's pretty quiet, and is pulling plenty of air. You could get a Maxx for about another hundred bucks. It might be worth it, if you're going to use your fan constantly like I do, or need a remote to properly operate it. Paying for the extra amenities and marginally higher quality might make sense..I don't regret getting this. If anything unpleasant happens in the future however, causing me to revise that assessment, I'll be sure to let you all know.---Further Comment, 06/07/2021The fan is performing very well. I'm pleased. I've decided that I don't need any external hood on this. When the lid is completely down the fan will not run. If you pop the lid to the point the fan runs and no higher, which is not all that much, maybe a half inch or so, rain will not get under it. Opening it much higher might not be wise, if you aren't paying attention to the weather, remembering to close it before precipitation.. But there's no need to open it higher, because you'll get full drag at minimum.. I recommend doing as I do; run slightly cracked, very mildly crazed.

They fit perfectly in our camper

This review is for the white units with the fan.Let’s start with the pros: Aesthetically, it’s nice. Looks great installed. Decent quality for a lower cost unit. It operates okay and will probably hold up for a while. It comes with 1/4” head stainless steel screws for the roof. Probably 1 1/4” long, give or take a 1/4”. It installed easily enough and I look forward to using it.There is a list of cons (or maybe just gripes): I’m not super happy with the low profile baffle being the only option. Yes, you can buy aftermarket ones that you can trim, but it would be nice if they at least offered that so I wouldn’t have had to drop an extra $20/ea. The white trim screws it came with for the baffle are so short. Like are we getting any meat with this thing at all? Thankfully I had some that worked.The screws that came with the crank handle are too long. I had to trim them down because otherwise the handle wobbles. Those are stainless steel machine screws, so not very soft for cutting and you risk messing up the threads (I’m a professional, so I had the right tools). One could use a small washer with the screw potentially. I wasn’t going to mess with that for aesthetic purposes.If you get the unit with a fan, it’s kind of noisy, but not in a fan being a fan kind of way. More like the motor is annoying. Suppose that can be replaced, but again with the aftermarket parts for a unit I just bought.Side note: These are very light filtering. I’m happy with that, but thought I should pass that along. I’d guess 90%+ light blockage. *Obviously when they’re opened that’s not the case.Gripes aside, I am happy with the purchase overall. Was fine putting in the extra elbow grease for the lower price. The only thing I’m docking one star for is the fan noise.Thank you for reading.

Easy kit to installn take 2 hours start to finish

Very satisfied and came with hardware

This vent is garbage. The cross brace that the gear box is mounted to broke in half the first trip out after installation. Spend the extra money for better a quality vent it will save you the time in having to cut out all that sealant used to install it.

As described

Easy to install