2Pcs Ice Ball Mould Ice Hockey Mould Whiskey Mold Ice Cube Trays 4 Hole DIY Ice Ball Maker for Cocktail Bourbon Juice Summer Drink

Disappointing as it leaks when trying to fill it and does not seem to seal even when gripping it firmly.Fortunately was not too expensive.

The idea of these are great, but sadly that’s where it ends. You cannot fill them to the top as the amount of water pushes the bottom ones to open. Once frozen they are extremely hard to remove (we have cuts to prove).

TLDR, these are great, buy them, get your ice balls in no time.We've experimented with other large ice moulds, squares, balls, characters etc, and these are without doubt the most successful we've ever tried. Gripping the bottom of the mould as you fill it from the tap keeps the water from leaking out, do not over fill, allowing small air bubbles to form in each of the 4 balls to avoid expansion during freezing, and run the frozen container under a cold tap briefly to loosen come removal time. Even a few whacks with a sharp knife can trim off any extra bits, like where the rubber bung goes over the filler cap, if you're that uptight about them being perfectly round (reader, I am that uptight...)Highly recommended, and so much cheaper than the ones advertised on FB that inspired me to look on here for something similar!

Wasn’t sure about these as people say they leak. And yes they do, but not a crazy amount. If you hold them tight you will be able to get amazing ice. Everyone commented. Thanks so much! Great but for the money!

the product does not fulfill its task after pouring water, the water automatically drips with small droplets, as a result, empty balls remain. Waste of money as you can see in the pictures, the containers are real empty, well, I gave them in addition to the container because I would have a flooded freezer

Unfortunately, and this is my fault, I didn't read the instructions that are on Amazon website when purchasing. After receiving, I was getting frustrated that the water was just running out of the other end but eventually managed to fill all of it but then discovered that you should only fill 3 and half balls. Just a suggestion but it would be good idea to have some instructions with the packet for idiots like me! Fortunately now that I know what to do there are no more problems. They are only £8 for them so no harm done.

Works well to make the ice and the balls look great in your drink, but my days they’re hard to get out. Plus if you can’t get them all out you can’t top it up because the frozen ball blocks the water into the rest of the mould

These were a great idea, but sadly, they are badly made and don’t work. They did not seal properly the first time so the water ended up frozen all over the freezer drawer. Second time I took extra care to ensure they were as tightly closed as possible and I got 4 excellent ice balls.Last time when I tried to remove the ice, the whole thing split and was unrepairableThey only cost the price of a large G and T but sadly they only lasted as long as one tooBrilliant idea, just need to be better. Sorry. Buy better alternatives people