KAIY Set of 3 Black Metal Guitar Control Knob, Guitar Volume Tone Control Dome Knobs, Tele Telecaster or Guitar Bass Replacement Parts

They're knobs. They do what they should.

perfectos y de buena calidad

They are not standard 6mm like advertised, much smaller than shaft and requires drilling to fit.. plus they give you 3 same size hex wrenches that don’t fit the screw!! Don’t waste your money like I did.

These are nice heavy metal knobs but like someone commented they may need some work to fit. They have a plastic insert which turns out to be a good thing. First, the Allen screw does not go all the way through so it won’t catch the spline. You have to drill a small hole so the Allen will go through and tighten on the spline. Second, they were too small and would not slide down over the spline. Again, I had to drill a bigger hole so it would fit. Since they have a soft plastic insert, it was relatively easy to do with a small cordless drill or you can ream them by hand. If you can do that, they look really good and doesn’t feel like cheap plastic knobs. For the price and looks, I would buy again now knowing what I may have to do. I would start with a small drill bit and gradually bigger until they fit. I’m happy how they came out. Good luck!

I had a bass that needed new knobs and these worked perfect! As long as the post is the right size or smaller you can use the Allen set screw to tighten it so they don't fall off. Great replacement. Looks nice too!

Purchased for use on an Ibanez SA series guitar with 6mm posts. Does not fit without modification. Also, comes with three Allen keys for some reason, none of which fit the grub screws. To install on a 6mm pot you will need to use a 1/4" drill bit to carefully bore out the hole for the post to get it to slide on. The set screws are non-functional to begin with... there's a thick layer of plastic at the bottom of the hole that the set screw goes into that prevents it from screwing all the way down to contact the post. Remove the set screw completely and use a tiny drill bit to drill through that plastic and clean out the hole enough to where the plastic is no longer in the way of the screw going all the way through into the interior of the knob. Once you do this it will fit, just takes some work.Aside from this, once installed they are solid and look good.

They work well.

As others have stated, shipped all together in one bag with 3(?) wrong sized Allen wrenches, so that everything is scratched up. Cheap knobs with a plastic insert. No reason for the set screw at all. Save your money.