Mxfans2PCS Titanium Al. Upgrade DriveShaft Replacement for AXIAL SCX10 Electric 4WD RC1:10 Off-Road Model Car

I put these on my 1.9 wraith, I ordered them thinking I wasn't going to use then on anything and for the price I gave it a shot. Perfect fit on the 1.9 wraith which means it should fit a scx10ii kit or RTR. I definitely wouldn't put these on a rig with a powerful brushless but for brushed they are fine and way better than stock axial shafts. one suggestion is take the pins that come in the stock shafts and use those on these shafts instead of the grub screws they provide.

Buen precio

I put these in my Scx 10, ran it for about 45 minutes then I found the weak point. I was crawling up an obstacle (not hard just a high angle dirt hill) and the back drive shaft just gave out. The shipping was fast and nothing to complain about but the quantity of the knuckles was low quality.

This will work with the Temper gen to with 313mm 4 link set up there a Lil finaky to get installed on the stock trans output shaft but it you get it aligned and the set screws tight it'll holdDon't have much run time on mine but it's held up to running around my house

Worked alright for my scx10ii but the bolts wore not through bolts so they didn't hold up as I wanted them too

I loved the product, good quality and well made, the product was used on a yacht to couple the Rudder angle sensor to a tie rod between the Rudders....

it is held together by tiny c-clips.I assume eventually I will drag a rock across one perfectly and I will lose that special pin and these will become useless without repair .hoping to superglue them in place.look pretty but are very low tolerance to fit and rather fat.if its a clearance issue be weary with these as they are fatter than the stock plastic and far fatter than a 50$ high carbon steel with a skinny shaft and high tolerances .seem like they will be strong enough for crawling as they are metal, just weeny pins and no pin keepers.not for speed runs though. these things are loosey goosey. sloppy and loud. but I dont care about that, you cant hear them at 1mph over the motor and tranny noises.seem to work at a very high angle. haven't tested in the field yet.

I with it could have been here in the set time date it had indicated. But it's all there and it looks great.

Exactly what I needed and fit perfect. Decent quality for the price. Runs smooth.

I bought these upgrade To grade from my plastic ones

After one day of normal use, the little pin that holds them together has already pushed its way into the housing, causing the driveshaft to stick and limit free movement... they look nice, but I would not recommend running these in your rc crawler

These are much better then the stock axles easy to install and look great! Worth every penny

works good but they are a tad wiggly, if I may say.