Rockford FosgateT750X1bd Power 750 Watt Class-bd Mono Amplifier

These amps are great as long as the amp isn't pushed too far! If the LED is hitting red the amp will overheat and smoke! It can flash the LED from blue to purple but never up so high that it flashes red. I know from a past 400 watt RMS FR amp I had it up so high that I didn't make it 4 blocks and the car had a strong smoked chips odor and had to shut off the amp to let it cool down. It only lasted a total of 4 years after I overheated the amp. If set up and calibrated properly these amps are just fine it is better than a class D amp and can pack some power. I have to turn down the volume within 30 minutes of full volume because it gets hard on the ears. One thing I did is pull down my back seats to ensure I wasn't over driving the amp using my rear view mirror to watch the LED.

Very powerful amplifier, using it to power to 12 inch pioneer shallow mount. Subs has more power than the Subs can handle so the game is turned down below halfway. I do wish I had planned ahead and got a higher wattage two channel amp of a similar size. But that may be an upgrade in the future for the next vehicle that I purchase or upgrade to can’t say anything but positive things about this app and manufacturer.

Amp clamps around 950 watts on music in my setup. It gets extremely hot but has not shut off yet. It is a very very small p the high level input and automatic on works amazing.Now for the cons. The terminals can barely fit 8 gauge wire. The power and ground are right next to eachother making installing large 4 gauge wire very tough. What you need to do is take your box cutter and spin it around the 4 gauge to cut the copper down around 40% at the end. Then put heat shrink so it protects the end up to the exposed copper. Then shove that thing in the terminal and clamp it down. For extra protection I snuck electrical tape between the two wires.They really just need to put the remote turn on terminal between power and ground and widen the plastic removeable terminal to allow the jacket of 4 gauge to enter. Then 5/5.

Birth sheet shows 1000 watts rms. This thing is small and will fit about anywhere. When i tested the amp myself I got around 960 watts at 1 ohm load. It does connect with 8 guage wire and is plenty and does not get hot. Make sure to use 8 guage all copper. The amp does have fans that run but I cannot hear them unless I put my ear next to it. This is made especially for restricted places such as a truck. I used in a 2019 new body style GMC Sierra. I wired it up to the rockford fosgate T1S-1x10P and it's a great match and room to add another sub if needed.

Great amp I have 3 one to each of my Rockford fosgate speakers

This lil amp is a beast, It was bench tested at a lil over 1k watts, 8 gauge power and ground wire is plenty to run it, have it hooked up to a RF 12in P3, it works like a champ, intend on running another 12in P3 to it, don’t let the size fool you, I bought a Prime 750 amp, installer thought I was running it to the main sub, nope, a bit pricey, but well worth it in quality and sound, and it works well with a punch bass knob

This amp is a perfect match for the T1 12 inch sub. If you want sq use a sealed enclosure and And make box big enough to compensate for speaker and the thickness of the wood. But stay to the specs and you will not be disappointed

Perfect size to place almost anywhere pushing two rockford fosgate p3sd2 10s