chenyang USB C DIY Connector USB 3.1 Type C 24Pin Male Plug ＆ Female Socket Port Repair Replacement Solder Adapter with PCB Board

These are perfect for DIY projects. I am using to charge batteries.Note: per usb 3.1 spec, power delivery and power consumption requires a microprocessor to communicate the protocol needed. I think using a reisistor on the D pins will allow 5v 1amp power, but I haven’t tested this. Currently my setups only work if there is a amp meter that only passes power. Not a big issue for me. Measuring 1.6amps via power only usb.

Purchased this primarily for the USB C female breakout board. Worked great for my Odroid Go Advance charging modification project. Quick tip, if all that’s needed is just 5v charging, you can cut the A10 and A11 side of the board to save some space when installing in space constrained areas.

I am using the male USB-C lead to power an RPi that controls an irrigation system. I attached the USB-C male connector to a 24v-to-5v converter. I only needed to solder VCC and GND wires on the male connector for this application. The soldering points are small and require some care when soldering, but have worked fine since. The price for USB-C connectors in general seem a bit high, and the price for these items were no exception to that. Both the male and female connectors are decent quality and securely connect to other USC-C components on other devices -- no play or connectivity issues once connected.

I only needed to do a little debugging of power adapters that I purchased. This worked fine. If I was doing more, I might want more connections on the board attached to the male labeled connector.

works well. hard to solder unless you use surface mount soldering iron.

Missing B4 & B9 pads.

Good, as described, on time

Photos for the male board show a resister pulling down to ground making it a sub-device, but the one i received has a resister pulling up instead.