Cooler Master Vertical GPU Holder Kit V2, for ATX Chassis & PCI-E 3.0 Devices, Modular Video Card Support, Includes 165mm Riser Cable V2, Thick SGCC Steel Bracket for Sturdiness - Black

It’s decently solid for a custom loop no movement or looseness which is what you need.In the NZXT 710, the cable was really snug and took a lot of persuasion and wasn’t very flexible, so full slide wasn’t possible. But there is a bit of wiggle room.

My case as seen on the pictures the clearance from the front Glass and the fans below is insane that is crazy and this card is a monster size wise.Also if you think about it, this kolink unity code case comes with a vertical bracket but I could not use it because it was sitting on on fans I mean virtually resting on the fans and was blocking air flow now look how high this cooler muster design does to that fans clearance best decision ever done and open my wallet for this and there is not GPU sag whatsoever is solid as a rock GPU temps went down from 80 under load to 60 using this vertical GPU as seen on pictures

Does the job nicely, easy to install. Be aware larger gpus may sag.

The media could not be loaded. Worked perfectly with my cooler master bracket, my 3080 would have all kinds of issues with a 3.0 pcie riser, this 4.0 one worked straight out the box without needing to change any bios settings, one note is the cable itself is a little stiff so needs some pre bending to get it to work nicely.

Well made and looks great when installed. However would not work with motherboard, probably due to the riser cable. Kept cutting out, black outs and interference... Had to return..Disappointing as cool master gear is usually good stuffTherefore cannot recommend and returned

The bracket is a good design in that you don’t need to damage your case in order to fit a vertical card, you will also need to buy an angled cable adapter or ensure your display cable is small enough to fit through your PCI slots.The issue with this is that it mounts the card a few inches into the case so it might fit right up against your front intake fans or radiator if you have one, for longer cards you risk it not fitting at all.There is another issue which is that the PCI cable bracket that holds the card up is actually raised off the bottom of the case higher than with other brackets.This means that the card sits higher in the case than is needed and if you have a large CPU cooler chances are it won’t fit underneath.In my case I had a Palit 1080 Super Jetstream which is a very large card, and a Noctua U12s in a Fractal meshify C and it just wouldn’t fit underneath the cooler with this bracket.I changed to the Phanteks bracket and it did fit as the bottom mount sits on the bottom of the case.Only downside is I had to remove one PCI slot bracket to get the cable in.So if you have either a very large case or a smaller graphics card then this might work for you but with large cards and midsize cases you might struggle.

Took 5 minutes to install, I had to slide the gpu over slightly for my chunky hdmi lead to fit to avoid cutting.If you get a low profile hdmi lead you could probably slide it back closer to the case.No sag on dual fan gpu.

Got this as I'd seen some YouTube videos on them. Very easy to install, had no issues.GPU does run a bit cooler, but partly due to a side intake slot for air.It almost contacts my CPU cooler in the vertical position so that was lucky.Plus nice to just see the GPU face really.