IPS Weld-On 3 Acrylic Plastic Cement with Weld-On Applicator Bottle with Needle, 4 oz Can, Clear

This product works well. It's extremely thin and evaporates quickly. It was difficult to unscrew the cap from the can but once this was done there is a snap-in insert in the opening that needs to be pried open. When I did this for the first time, the insert went airborne. I used the product and it worked. When I went to use it a second time, the insert popped again but not as high. Just be aware of this when you use it.It also dissipates very quickly. You must be fast when using the product. I used a brush to apply it to the acrylic that I was gluing. It evaporates instantly so I had to re-load the brush multiple times to get enough of the product onto my project. FYI.

Works well but difficult to pour into dispenser from can. No cap for needle

Excellent & fast welding of Acrylic plastics. Would have given 5 stars but applicator, which is required, is almost impossible to use. It leaks extremely bad and the tip is so thin it flicks droplets everywhere and where they land on your work pieces they leave un-removable marks.

Excellent product, easy to use. Have been using it for years. Quality product

I have used many different types of bonding agents. Everything from the cheapest pack you can buy at the dollar store all the way to the most expensive I could purchase like locktight, and gorilla glue. I typically like to find products that are specific for the project I'm working with. In this case it was plexiglass, or acrylic. This product was described as fast acting and strong and for a reasonable price. Or so I thought. It comes in a metal can which in its self is horrible to work with. There is a piece of metal that you have to remove in order to even open the can. Hopefully in doing so you don't damage the threads for the cap. It comes with a small bottle and a needle like tip/applicator and that would be fine if the liquid wasn't so thin that when applied to the material it basically runs all over it. Not good if you're looking for a finished looking project that doesn't require additional work in order to do so. Not to mention you will waste quite a bit just trying to pour the liquid from the can to the bottle. In my opinion you would be better off sticking with gorilla glue or locktight rather than this stuff. All puns intended.

I was a bit disappointed that the expiration data was April 2025. It worked OK but an excellent date is on there for some reason.

Amazing product, but very difficult to use because it's so thin. Make sure everything is set up perfectly and tape up areas that could be in the accidental spill zone. Have towels on hand. Drives super quick so you don't need to clamp too long

This is not available anywhere in Hawaii if you're working with polycarbonate material. Thank goodness Amazon can ship it here.