Adviace Grill Replacement Parts for Charbroil 463449914, 463241113 Gas Grills, Pipe Burner Tube, Heat Plate Tent Shield, Crossover Tube, Grill Igniter for CharBroil Commercial 4-Burner Gas Grills

This product is a perfect replacement for our propane gas grill parts. It took about 15 minutes to replace all the parts included with this "rebuild" kit. We expect to get several more years out of our grill. Our grill is 10 years old and the manufacturer no longer offers these parts. Was glad to find these at a very reasonable price. Grill fired up immediately and runs like it was brand new.

installs in 15 minutes depending on how rusted your old parts are, but the new parts go on in just a few minutes. I will uses this again, saved me hundreds not having to replace a grill

Easy install of most parts based on what I saw in current grill, but no instructions were included just the parts. My grill was rusted through so installing the new gas tubes was easy as the old ones disintegrated I would recommend buying this rebuild kit every couple of years

Fit my grill well and everything worked wonderfully.

Two of my four pipe burner tubes were completely rusted through along the small gas port holes so I bought this full replacement kit. It took more time to take the old rusted parts out than install the new kit. My cotter pins holding the gas tube onto the back of the BBQ were rusted and two cotter pins broke during disassembly. This required more rust removal with a wire brush and a little forceful coaxing to remove the little piece of pin still in the retaining post and pin hole.I didn't really need new igniters since mine worked fine, but for a few extra bucks, it was worth having the spare parts. I'm very glad I bought the full kit because reusing the old igniters was going to be a major pain to get them off the old burners and I am sure I would have had to buy clamps to get them to stay on the new burner tubes. At first the new igniters don't look like they will fit around the new tubes, so I gently widened the first igniter clamp a little. Turns out it now fit over the burner, but it was too wide to grab both notches to stay on the burner. The half round shape of the igniter clamp is just a bit off and likely on purpose to provide some grab strength when assembled. After a little readjustment it held onto the tube on its own. For the remaining three igniters, I would hook one side by hand and pull the other side over the tube notch with pliers until it would catch. It looks like it is a little unstable, but it holds. In the end, I am sure I have extended the life of my old BBQ a few years. The new parts are a thinner gauge steel than the original and the drip plates are not coated, so I only gave three stars for longevity. There is no way these replacement parts will last the same 10 years outside uncovered in the northern US as the originals. But, for the price, it will do. I suspect by the time these parts were out, the back of my BBQ and grease tray that are also rusting bad will be shot anyways. It was worth the price and little extra effort.

Perfect replacement parts for my charbroil gas grill. If your firebox is still in good condition, not rusted out,it will extend the grill life for another few years

Direct replacement for my Charbroil grill, and noticed better temperatures right away. Cheaper than buying a whole new grill, and better price than OEM replacements. I also noticed that the flame pattern is different than the original parts, which seems to be a little more effecient.

Purchased in March 2023. It is now July 2024. Grilling season is definitely not even close to being over this year, Parts have already rusted and broken through. Material seems to be a low quality. Was really hoping to get at least three years out of it.