Gunite Spiked Shoes With 3/4” Short Spikes Perfect For Epoxy Floor

These spiked shoe (platform) attachments worked well. I used them twice when I applied two coats of gray Epoxy Shield to my garage floor, and again when I applied the clear coat. Here's a summary of my experience with this product: -- The platforms come unassembled. You must insert a spike into each of the many holes in each one, spin on the nut for each spike, and then tighten with the wrench that comes with the kit. That was easy. -- You must then thread the strap through the platform slots. This will take some trial-and-error effort to position the straps for use. Be sure to thread the straps so they don't cover the spikes in any fashion; loop them back up over the top surface of the platform. Admittedly, this one is hard to explain. Maybe read the directions (which I only do after the project is over, which is a genetic trait in my case). -- To attach the spiked platforms to the bottom of your shoes, you step on the platform, tighten the straps, and tie the excess strapping in a knot to prevent the straps from dragging into the epoxy on the floor. -- Once ready to walk on the floor, BE VERY CAREFUL -- again, BE VERY CAREFUL. These are not shoes. The many fine points that touch the wet epoxy do not grip the floor whatsoever. If you shift your weight (e.g., lean in any direction), the platforms will slip. Falling into epoxy could hurt you, give you a permanent hairdo, and waterproof your clothes all at the same time. As corny as this sounds, take a test walk with someone at your side before you begin to use these platforms. At the end of the day, these platforms did their job. You won't see a single mark in your epoxied finish.

The actual item quality is good but the straps aren't that good they broke on the first use, once i replaced the straps for better ones I haven't had any issues since then, they are easy to use and one size fits all.

Worked enough to paint 665ft2 of floor with epoxy paint and sprinkle chips. But just barely. The nuts holding the spike on kept falling off at an alarming rate and I snapped a spike when I slipped. Broke a strap tightening and had to tie off. Good for small DIY projects if you’re doing more than 500ft2 get something higher quality. Bottom line, great for price point but I would not buy again.

This thing has Terribly Weak Strap Buckles. The buckle shattered the first time I put both of these on. I test fit one shoe once. then today I finally got the chance to dye my driveway pavers, I'm at the point I need them and I strap into them and the buckle literally shattered into several pieces so I had to do without. I bought these specifically for this project. The rest of the thing is fine, you have to assemble it but no big deal.

Does the job for the money you pay. Easy to use in my opinion. Have to assemble the spikes but it only takes a few minutes. Comes with a wrench to tighten the spikes. Been used a few times now with no issues at all.

Inferior product quality, weak plastic sole, broken after 3rd use, strap clasp broke after 2nd use.

Very useful when painting a floor

Very good and easy to use.

Fácil de montar y bueno para trabajos de construcción.

Nadaje się do wylewki samopoziomującej. Dobry produkt

Bought these as I needed to latex a large floor by myself where walking through it and rolling at the end made the task easier with a better finish The straps were my concern - but they held on - diddnt slip and lived to fight another day!!!

Really good job for self levelling

Je le recommande pour le prix utile