Willsenton R8 KT88 Tube Ampliifer Silver

So let me start out by saying that this purchase was years in the making. I had seen several tube amplifiers that could use both EL34 and KT88 tubes and one in particular that also had triode and ultralinear operating modes. My end goal was to replace several tube amplifiers including my ancient yet beloved Dynaco Stereo 70 (ST70). It should be noted that several years ago I purchased a Yaqin MC-100 amplifier but my ST70 was simply better sounding so I sold it and started my search anew. For better or worse, I'm not a wealthy audiophile but I am a very good technician so I've been able to buy most of my audio equipment broken for pennies on the dollar and then over months or years, repair it as I acquire parts. This time however, I wanted something new so this was like buying a new major appliance since it cost the same as my washer and dryer. That notwithstanding, let me tell you about this amp. When the Willsenton R8 (R8) arrived, I was pleasantly surprised to find it was triple boxed. Given the weight of this amp is over 70 pounds it needed to be well protected for shipping and it's clear from the weight this is not cheap amp. My ST70 is light as a feather in comparison. One thing I found interesting is that it shipped with the tubes already installed but there was sufficient styrofoam and tape to keep the tubes in place. Nothing was broken and my poor body survived lifting it onto the audio stand (I still got it!). On the features front, the amp comes with a high quality machined aluminum remote. The remote has no power button but does have an oddly large mute button (huh?). The amplifier itself does not have a VU meter but features a large easy to use bias meter. Keeping with the quality theme, the power and volume buttons are machined aluminum with LED illumination (red for power and green for volume) as are the selector and TR/UL buttons. A tube cage is included and the vacuum tubes are Willsenton branded so clearly a lot of care was taken to continue the quality theme. Even without having heard a single note from this amplifier, I knew I had a beautiful piece of audio jewelry for my listening room. My first impression of the amplifier was positive when I turned it on and heard nothing after hearing the startup relay click on. No hiss, no hum, just silence. The amplifier defaults to triode mode when powered on and my first listen was Introit from Faure Requiem (Naxos). Playing through my Infinity Primus 363 towers, the opening pipe organ chord filled the room with power and authority rivaling some of the best tube amps I've heard and certainly better than any I've owned. About three weeks in, I had used the amplifier enough for the tubes to settle in and now there is a greater smoothness to the sound (it was never harsh) and I can easily hear a stark contrast between triode and ultralinear modes. It should be noted that I had a Yaqin MC-100 amp and the difference in the modes was barely audible. In comparison to my ST70, the R8 is a very different sound which is to be expected since they use both different types and brands of tubes and the ST70 uses tube rectification while the R8's rectifier is solid state. I cannot say that one is better than the other as I enjoy them equally. In conclusion, I must say that the Willsenton R8 is a fine amplifier. While it is by no means inexpensive, it is certainly a value leader as it is less than half the price of competitive "brand name" equipment while yielding uncompromising build and sound quality. While sound quality can certainly be improved (or diminished) by changing vacuum tubes, the buyer of the R8 can rest assured that the branded tubes that come with the unit are by no means a cheap add-on. I'm pleased to say that the engineering and care that went into the build and parts selection of this amplifier are worthy of the best brand names. Thanks for reading!

This is my second tube amp and I am highly impressed. I did a lot of research on it before hand and knew about the issues, but this is the revised version as per Skunkie Designs recommendations. It is built like a tank but in a very classy and refined way. When turned on it defaults to Triode mode which puts out less power than the Ultra Linear mode. Both ways sound fine but I leave it in Triode since my Zu Audio DW6 speakers are very efficient. When received the power tubes bias checked just slightly to the right which was very easy to adjust with the included little screw driver. When first turned on I was rather shocked as it sounded very dull and dead, nothing like my Cayin 10 wpc tube amp. But running it with streaming music for about three hours was like flipping a switch and the audio quality really blossomed. I am very pleased with the sound of the stock KT88 tubes, but I have purchased a matched quad of Mullard EL34 tubes to try some time in the future. The volume control is silky smooth, and works very well with the included remote control. The remote is all metal and rather heavy, with edges that are a bit sharp, so be careful not to drop it on anything. It controls volume, mute, source selection and tube mode. The battery access is a pain as you have to remove six small screws to remove the back plate. This amp can be ordered straight from China, but I preferred to pay the extra cost and have the excellent backing of Amazon in case of a problem. Even at that this thing is a real bargain in my mind, and I have no regrets so far. As I am typing this I am enjoying it streaming in the background, and now I think I will spin a few LPs to get an even better musical experience. Highly recommended.

This is my first tube amp, and it sounds so much better than most of my solid state amps. What I mean by that is it sounds more real, the soundstage is better, it is more airy, more detail, especially in ultra liner mode. Most of my solid state amps, including some made in the USA amps, just sound less real, dead in comparison. The 43 watts also gets very loud with my 86db sensitive speakers. 43 watts of tube amp is like a much higher wattage solid state amp. Tube amps have output transformers that block dc , so when the amp clips it clips softly as the output transformer prevents dc from being sent to the speakers, where as a solid state amp when it clips puts full dc rail voltage on the speaker, and boom, there goes your tweeter. My point, don’t listen to the hifi salesman that say…ohh you need 200 watts of headroom for those speakers. That might be true for solid state as if you clip, you blow speakers, but not for tube gear, at least once you get up to these power levels. My amp puts out a solid 43 watts before it starts to clip, it puts out a little more power at the THD levels they speciy. It is an amp the performs as advertised. I say most, as this sounds as good,as a $3500 solid state setup I have. They made some improvements recently and this is a good buy. It is tube gear so you may still want to upgrade tubes or buy a spare set in case something happens, you can troubleshoot., but if you have a problem, contact the factory first, they are eager to help. The input selector will make a little pop in the speakers when changing inputs, it will make a little pop, when switching between ultra linear and triode mode, it will make a little pop when turning off. But it is not substantial enough to damage anything, just a little annoying. Tube gear is just going to be like this, it is nearly 100 year old tech, but sounds great. Just beware, tubes do not last forever, but they should last 1000 to 2000 hours before they start to degrade and decent tubes these days cost at minimum $400 these days for a whole set. Tube amps are a bit different that way. The spec on Amazon when I bought mine said it was for 115 volts +/- 5%. That is roughly 109 to 121 volts. If the voltage at your house is outside of that range, like mine is, you probably should find a variant with a transformer better matched to your normal household voltage, but most of the US should be well serviced by this unit. The manufacturer does make them with 110v +/- 5% and 120v +/-% versions. Tube gear is more sensitive to input voltage variation and this really can not be helped. It is just inherent to tube gear, all tube gear. This is a great sounding, good looking, solidly built unit. Is it as good as competing amps costing two to three time as much? Probably not, but I suspect it sounds just as good. It does sound great. I bought this because I always heard of the tube sound, and at this price it is finally seemed within reach. If that sounds like you, then go ahead and buy this thing, it sounds great.

The exterior build quality and sound are excellent! easily comparable to my older PrimaLuna. The R8 with my KLH 5's have great synergy, much better than with my Yamaha AS1100 or NAD separates. Unfortunately, after four days the input switching board on the R8 failed. I returned the unit to Amazon and ordered another one. The new unit arrived with shipping damage; I was also disappointed to find the interior box that contained the R8 had been opened. Clearly this unit had been dropped at some point. Despite this, I'll order another one when Amazon gets caught up with my return's and credits my account. Update! Finally received my refund from Amazon and decided to order yet another amp! Unfortunately the volume control had an issue. When I turned the volume up with the remote the knob wouldn’t turn past the eleven o’clock position. I could manually override it but it felt rough and appeared to be binding. The V/C is supposed to be an alps , highly doubtful imho. Amp’s been returned and I’ve given up on the R8! To bad because it’s great sounding unit.

I got my R8. Shipped fast and in good shape when arrived the sound is great. My only complaint kinda a big one is that the configuration of my tubes when taken out of the boxs was different then any R8 I've seen. V5 and v9 were 6SL7. V6-V7-V8 are 6SN7. It makes the look of the unit ununiformed. When I swithced them to the placement the manual states the left channel is muffled. So I believe mine was wired this way. Kind of ticks me off for the price you pay!!

If your speakers sound thin this amp will definitely plump up the sound. However in my system the bass was bloated and lacked detail. It was good with female vocals and brass but that was about it. Quality control issues: one of the tubes seemed to have a residue inside. There was a scratch on the back near the RCA inputs. Also, not all of the RCA inputs or even the speaker terminals were the same depth so some cables hung further out off the back of the unit. So despite being a 70 pound tank, the build quality was not up to the standard of your typical $2000 amplifier. It was a fun experiment but it is not on the level of brands like Hegel, NAD, Yamaha, and Marantz in this price point. P.S. The remote and manual for this unit were pretty embarrassing. Those weren't a deal breaker but the sound quality and physical flaws were.

My first tube amplifier. This lives up to the hype. There are a number of Chinese amplifier manufacturers at the present time like Willsenton making very good high quality equipment at hard to believe low prices. I love this amp.

Very special tube amp for the price. Impressed. Really ! Watch your back if you carry it. That thing weighs like lead...