CarBole Micro Electric Gasoline Fuel Pump Universal 5/16 inch Inlet and Outlet 12V 1-2A 35GPH 4-7 P.S.I. Operating Fuel Pressure

The media could not be loaded. Saw a YouTube using this as part of Filtering Water from a Boat Fuel tank.Combined it with a Water filter, Cutting Board and some 3/8" hose to filter 30 Gal tank on Party Barge.Worked well, about 12 oz of water in an hour.

Stopped working after 2 weeks. Checked fuse checked relay everything in working order. Except pump. Don't know what's going on.

GREAT PRICE, WORKS AS IT SHOULD. A+

The media could not be loaded. @weaverstonehousefarm on YouTubePressure is 7psi on my gauge in the video.Even at full throttle on my IH 444 tractor it works fine. The bolt holes line up with the factory pump holes.It has a 5/16” smooth barb outlet connection for a rubber fuel line. It’s can’t be removed or replaced.I wish that outlet was threaded. There are other models with a threaded outlet.Inlet is threaded. Possibly 1/4” FPT.I got tired of every 3-4 years replacing the $60-80 dollar pump from NAPA.For the twenty something dollars it will work and looks similar.I tried this higher pressure pump as the 2-3 psi pumps would barely put out 2psi.Wiring was simple 12+volt DC positive and the ground wire to the bolt for the base.It comes with mounting bolts.We make hay and run our equipment in the worst and hottest parts of the summer so it’s expected that and electric fuel pump w/o any external cooling will eventually fail for us. It gets so hot sometimes when making hay the fuel will boil in the tank.

Zero Review. This pump failed in about 10 miles. Started out with 7 psi. My car would no longer run at 2 psi.Had to tow my car home. #chinagrifter #ZERO

Bought this little pump as I need to defuel my boat. Got tired of manually pumping. This pump works just fine. Not its intended purpose but suits the process just fine. Going to keep it around for other side jobs once done. Not very noisy. Did not get hot. Direction of flow clearly marked. Plugged in hose and connected power to get the job done without any problem.

Does everything I want for my Holley 650 4 barrel carburetor on my truck -1975 IH 1600--------------------I have been asked a lot of questions by people from Amazon about this fuel pump.The biggest question I get - will it work on a particular model. Sometimes I can answer that question, while others are not sure. When it comes down to carburetors each has a certain PSI for fuel pressure rating. These need to be match. If a carb is rated @ 6psi then the fuel pump should be @ 5 PSI or a little less . If you get too much PSI, the float in the carb WILL NOT shut off. This will cause the carb to flood fuel everywhere in & on the engine. Not enough PSI might cause low fuel delivery. The other item is GPH {gallons per minute}, in most cases this is not important issue, unless you got a rocket vehicle that needs massive fuel delivery. Also I have been asked about the mounting positions, I always try to mount it feet down and also close to the fuel supply {tank} as possible. A general rule to any type pump, it can push liquid farther than it can pull it {from tank}. Hope this helps.

In about a year I noticed it leaks when pumping. It is quiet and worked well until recent.