EVERGD 90W 220V Automatic Water Pressure Booster Pump Shower Household Boost Pressure and Circulate Water for Home Garden

It arrived quicker than I thought and it seems simple enough to install I just haven’t installed it yet there’s a few parts that I need to get my reduces but other than that it looks like it’s going to do a good job!

The pump is great, does the job fine.BEFORE USE, CHECK THE FUSE!Mine had a 1 mm thick piece of copper wire soldered across the ends of the fuse, which would never have blown in an incident, making it lethal! It was bad enough having a 13 amp fuse for a 9 Watt pump (3 amp would have been fine) but this is ridiculous!

Fitted to a hot water a lid style cylinder that has a very low head of water on ground floor wich gives the shower no pressure by filling it it gives about a 1 Bar pressure to hot supply an to get the cold water that is at 3.5 Bar I fitted a pressure reducing valve and set it to the same pressure wich gives a good shower at head just have to make sure to only use for no more than 4/5 minutes as tank will run dry good for quick shower or washing hair only

Bought this pump for suppling water in a house boat unfortunately it can’t lift water but would be suitable for increasing water pressure if it had a low pressure source on the suction sideSo have to send it back.

Works perfectly to boost the water pressure

A good little pump if you follow the instructions. It must however be set below the water tank as it requires some pressure to start working so not suitable for low pressure water systems.

Very good

I used this to water my greenhouse. It is plumbed into two 1000 litre IBC tanks which have 80mm exits and sit 3 feet off the ground. The pressure at 3 feet high in the greenhouse with this pump is just about sufficient to water plants with a trickle as opposed to any force. I cannot imagine it giving any real boost to a shower head.Further to that the connections were hard to match with standard plumbing fittings especially on the exit side where the connection is not chamfered to take an 1/2" olive. Tightening the joints was also difficult as there is no edges to grip per say.The pump also gets "very" hot after a short time. You wouldn't put your hand on it for sure!