Hi-Tech Custom's KS7 Barrel Nut Remover Tool

I did not have to use an impact wrench or anything with this. I set the fully un-loaded and cleared KS7 on the floor and kneeled on it with one knee, and used this socket tool with a decent sized hand wrench. I applied slow, steady turning pressure. Took me two tries and less than 30 seconds. It would have been easier with two people working together but it was relatively easy for me. A MUST HAVE for adding choke adapters or other barrel mods to your KS7.

Wrong spacers.

I've bought a few items from High Tech customs both through Amazon, and through their online shop. I recently purchased the wrong custom part (my fault). They responded in less than 2 business hours and replaced/ refunded the item in less than 3 days. These are people that really care about what they do, and it shows.

Sucks that you have to buy a special socket but this one is well-made and worked fine for my KS7 (same nut as KSG)

Worked great. If you hit the barrel nut with a torch for around 10-20 seconds it'll help loosen up the threadlocker and make it come off a lot easier.

This isn’t like described, the socket side is too big for traditional sockets. Also, the factory nut is on the gun about as secure as Fort Knox. Will not buy from this seller again.

You can't use a normal socket you have to have this if you don't want damage your ks7

This makes removing the barrel nut so much easier!