MOOG K80820 Suspension Stabilizer Bar Bushing Kit for Toyota Tacoma

2003 V-8 4runner Limited 4WD. If you are going to leave the factory skid plate in place to change these out then you need to determine whether you have the right length socket extension. Not all short 3/8 drive extensions are the same length and the head of the bolts that are holding up the sway bar bushing brackets line RIGHT up with the edge of the skid plate, unfortunately. It was also a little tricky to get one of the holes lined up during the reinstallation of the bracket so be sure to have a good long and thick screwdriver handy to line up the bracket to the frame bolt hole for the bolt to enter so you can start some threads.I am not sure I could feel much of a difference and worst of all I still have a clunk. My sway bar end links are good, new ball joints, whole new rack and pinion with inner tie rods. 3 year old ToyTech lift with Bilsteins that are still good and not leaking.This is still a good product and certainly worth the money and DIY time and effort. If for nothing else do this for the process of elimination if you are hunting down a clunk.

I don't normally write a review but these work great! I have a 2006 4runner with a 30mm sway bar. I had a clunk noise when going over bumps so I replaced sway bar end links and these sway bar bushings. Even though the end links did not help the noise, they were blown out so that's good. Next I installed these bushings and boom, noise is gone. They fit perfect!Be careful removing the bolts on the bracket. The nuts are inside the tube frame and lightly tacked in place. One side went from a 10min job to a 1-1/2 job. I don't know how long the bushings will last but its easy to swap so if it's once a year, no biggy.

The media could not be loaded. Perfect OEM fit, very durable, and works great with my 3 inch suspension lift from Iron Man 4x4 America. I replaced the front swaybar links with Moog parts as well. I replaced both sides on my 2008 Toyota 4runner limited V8 4 x 4 in action in the video. You can’t see the parts, but they are on there in the video

Super easy to install, but BE CAREFUL, that sway bar will swing down and hit you, ask me how I know haha! Easy and fast installation on my 2003 4Runner!

This fits 4th gen 4Runner, you can install w/o removing the front tires nor skid plate, it's easier if you just go ahead and remove the front skid plate. We replaced these while replacing upper control arms, so the skid plate and tires were already removed.

Fit could be better, it's a little loose on the swaybar

Quality feels good. Installation fit was good. Would buy again.

These solved a clunking noise I had when going over bumps. My old bushing was worn enough that I could move the sway bar by hand. Perfect fit on a 2006 Toyota 4runner.