Makita 194419-4 118" Splinter Guard Replacement Strip, Black

The adhesive is very good and will work on any track.

Used to replace the strip on my festool rail. Fit works perfectly. Most strips I use don’t stay on well in high summer temps. Hope these survive our heat. I read complaints about the solvent smell but it dissipates after unfurling and installation. Great value so far

Works well on my Festool tracks. Cheaper than the Festool and similar function. Sticks well and no problems so far.

It's a replacement splinter guard. I bought the longer roll and just cut it to fit my shorter Makita tracksaw guide. That way I can get 2 replacements worth from a single roll.It's important to take the time to clean all of the previous strips adhesive off of the guide before you install this one. I accomplish this by taking a heat gun and warming the edge up until just warm to the touch. Take 90+% alcohol and soak the edge with the residual adhesive, after about 15 seconds I carefully scrape with a razor blade, cleaning the gunk that comes off as I go. Repeat until its just the raw metal. Dry the area you just cleaned and allow it to sit for about 2 minutes so all the alcohol evaporates. Then carefully adhere the new strip in the correct orientation(yes there is a correct orientation), with the sticky portion to the inside of the guide going slowly to ensure you keep it right up against the shoulder. Once done I take a J-Roller and roll the strip to ensure it's been properly seated to the guide.Doing all that, the replacement looks straight out of the factory and I don't have any issues with the adhesive not bonding to the track guide.

These are better than either the Milwaukee or Festool replacements. Just be sure you use a heat gun to get the old splinter strip off clean, otherwise it may leave behind a mess of glue residue.

I've got a cheap wen track saw. It works for my needs but the splinter guard didn't stick very well and I've had to re-adhere it several times. Gave up and replaced with these...good width and thickness on the Wen tracks and the adhesive flat sticks. I did have to clean the tracks after removing the old splinter guard, using acetone, as I had some mixture of old adhesive and contact cement I'd aggie engineered earlier repairs, but it was a clean replacement after that.

Very hand to have on hand when replacing worn out strips. It is better to have it available than waiting to set it up. They do last. I use my track saw daily

Sticks better than the festool product and is much cheaper. I wish they were clear like festool ones. These are for my tracksaw guides..