Marine Fuel Gauge Car 2" 52mm Gas Tank Fuel Fuel Level Gauge Meter with Fuel Sensor E-1/2-F Pointer Universal Kit for Car Boat Marine

Fairly easy to follow the instructions on how to cut down the float wire and adjust the sending unit heights. However once adjusted the sending unit wouldn’t fit in my tank opening and I needed to take off the excess part in order for the float, wire, and sending unit to go into the gas tank. I will need to make a few more fabrications as now that the excess part is off the gauge only reads half full when it is full, I am think they float is limited to moving all the way up although I did use the guide to measure both items needed before installing.

To fit my fuel tank I had to remove the float and attach it to my tank fuel intake and tank attachment. i haven't been able to make it work but that might be my fault. The other thing is that the diameter of the gauge does notfit very well in the standard hole in my truck dash. Cheap though.

I installed this gauge and sender on my tractor. It worked well when first installed, but the gauge quickly showed signs that moisture was getting into the gauge, and it stopped working. WARNING: Do not purchase this gauge if it will be exposed to the weather.

Gauge works fine, the only problem was the bolt hole pattern in the sender didn't match the pattern on the tank. I had to redrill all 5 holes in the sender to fit the tank.

I like the product because it did work I dislike the product because I had to modify it to make it work. It's all good though 😎

Did not include a gasket and some screws that were stated as in the kit were missing. I also never received any instructions. Overall, the gauge and sensor work (so-far), but are flimsily built.

Got it to work after cutting to fit in sender hole ... works good just be sure u cut float per instructions

I installed it in a fuel cell it's a little off but not enough to worry about it's with in a 1/8 on the accuracy so I stay above a 1/4 tank