Du-Bro 915 Mini E/Z Connector (12-Pack)

These are the best of their type for small RC aircraft. Pricier than the others, but worth it. Not a place you want to skimp.

Most people may not bother to rate this item but I will because it is essential to bring to your attention a point, if you use this connector on your glider, listen up! The screw on this unit is very delicate and it can drive you nuts! It will twist off if you turn it too hard. First be sure it is where you want it to be for the trimming of your aircraft. then snug it but don't over tighten it. Then use a sharp toothpick and apply a tiny dab of CA thick glue to the front and back of the stud, on the wire (control rod) each side. You can use fingernail polish or your favorite thing. You might be safer to use wheel collars on each side of the studs.Slide one on ahead of the stud and one behind and tighten down.follow the instructions. for the rest of the application.

They worked just as expected but the price for the 2 pk was expensive. The only reason I paid it was that I had lost one and it was holding up the completion of a build.

A bit pricey for a few tiny bits, but they make linkage so much easier on small servos. Happy customer.

I have been using these for control linkages on my builds for years and have never had one fail! The convenience of being able to adjust your control surfaces by simply loosening the set screw makes for perfect adjustments without having to use up the trims on the radio is great! I like keeping items like these on hand for my build table so buying them in a large amounts is great. Reasonably priced and fast shipping. Highly recommended.

Last batch had a lot of pieces that needed to be hand drilled - Large Metal barbs in the hole where the wire fits - I may resort to using larger ones in the future.

For the small end of the air craft application they are perfect.

These mini connectors make the job of connecting small servos to their associated control surfaces a snap.I still need to run a 1/16th inch drill bit through the servo horn to provide enough clearance for the connector peg.No problems so far with these breaking or loosening.I just wish they were a little less expensive.