C2G Wiremold Floor Cord Management Kit, Corduct, Cord Protector, Wire Organizer and Hider, Rubber Cable Cover and Concealer, Gray, 5 Feet, CDG-5

We purchased this protective strip to protect our copper fuel line feeding our burner. It is made with strong rubber construction that has a slit in the bottom making it easy to bend to open and slide our copper line inside to keep it safe. It leaves a very easy slope to step on and over with no damage to copper tubing. Very satisfied with this choice.

This strip is of good quality and the size was just about right for multiple speaker wire (4 x16 gauge although it was a tight fit). The adhesive worked well on laminate flooring, holding it doesn't damage the flooring when eventually removed. It order to get this to lay flat, you'll need to unroll it and roll it in the opposite direction for 12 to 24 hours. Once you have your wires inserted and have "carefully" removed the thin clear protective layer that covers the adhesive, you will need to apply pressure and hold it in position for a few minutes and will likely need to place some weighted material (books, weights, etc.) on each of the ends (depending upon how many wires you've inserted) to ensure that they will remain flat and allow the adhesive to stay bonded for at least 24 hours (I left the weights on for a few days since I packed it with the maximum number of cables it would hold). YMMV

I've got 8 total wires ( 4 speakers ) going through it. It works pretty well. It's a little warp and you can always cut it to size if its too long.

I bought this product about 3-4 years ago and I am now reviewing this but would like to say that I have just came across some spare wire protective covers in my room and I needed some spare and would like to say that this product came in handy when my cats were kittens when they used to chew up my wires especially on my power strip, when I replaced my power strip I put this cover on and since then It protects my wires very well and even hides the cables well. It is very sturdy and sits well behind my desk without any issues after 3-4 years and still holds up to this date.

Just like the headline says, it comes rolled up and is VERY difficult to get straightened out. I took a hot air gun to it for like 10 minutes before tripping a breaker and it still wanted to roll up. I had to leave it for a couple of days in the Arizona sun in the middle of summer for it to finally want to stay straightened out.Additionally, the included 2 sided tape is horrible. For semi permanent installation, I recommend getting some VHB or Gorilla Tape.

Wiremold for protection of wires that need to cross foot traffic areas so that people do not trip over the wires. The construction of the wiremold is such that it prevents the slippage of the wiremold on the floor very well, though this is NOT adhesion. It has no Drying Power other than it may keep the cable from becoming saturated with water that may be spilled on the floor. The material is such that it appears to be very sturdy in protection of the wire on a high foot traffic area, and keeping it all safe.

These work great just lay them outside in the sun to get them to relax before installing

I purchased this to help with cable management in my classroom. It was a little tricky to set up, as it comes rolled up. It takes a little finessing to get it to stop curling up. The double-sided tape it comes with is strong enough to hold it down, but I definitely struggled a little making sure the tape didn't stick to itself while I was unfurling the cord protector. It probably would have been easier if I had another person there to hold down one side while I stuck it down to the floor.Overall, good product, just a little finicky to put down.