Chevrolet Performance 14097395 Hydraulic Roller Camshaft

Perfect for our application

The media could not be loaded. I put this in my 91 305 tbi. What a difference it made on low end and too rpm. Nice idle too. Make sure your old engine can handle 6k rpm. I did rod bearings, oil pump, front and rear mains as well pan gasket, timing chain and took oem lifters apart to clean. Check your worn out valve springs too.

Put this in my ‘57 chevy truck that has a ‘89 corvette 350 using a carburetor.Smooth idle, torquey cam.I am used to the power level, and moving up to 1.6 rockers.If it’s not a noticeable increase in power, i have another set if heads i want to put in it.The heads are factory corvette aluminum TPI heads, with 58cc combustion chambers.New heads are 64cc, and should make good use of the aluminum intake, 1.6 rockers and this cam.So far, my current combination runs out of steam at around 90 mph, but the ‘ol 57 isn’t known for aerodynamics. It’s pushing a lot of wind.So cheers, this is a great cam for torqe and gas mileage on a factory roller block.Use synthetic oil and get about 2 more miles per gallon!

Don’t waste your money you can get this camshaft for $90-$100 cheaper directly through GM or through Summit or Jegs !