Vacuum Brush Head for Henry Hoover Head Attachments 32mm Compatible with Numatic Henry Hetty Hoover James and NRV Dual Pedal 270mm Wide Floor & Carpet Tool Nozzle Head for Henry Vacuum Head Cleaners

Very nice quality

Not sure if it's a genuine henry hoover foot but it does the job and there is no clipp on it to clip it on to the hoover but does what it is meant to do.

Great hoover head brush picks dogs hair perfect

Replaced our hoover head. New one not as wide as original but works ok

Didn’t fit. Not the same as the authentic Henry and didn’t glide forward or backward on carpet. Not usable.

This is a well made Henry/Hetty, etc. compatible vacuum cleaner brush.It has two separate foot pedals built into the brush for brush down or up.There are two red coloured Velcro strips set beneath the brush at the front and rear of the suction hole.See the photographs.I gave this three stars out of a possible five for the following reasons.There are too many gaps cut out of the brushes compared to the originals, so less agitation of a carpet or rug.The quality of the brush's finish is not as good as that of a Henry/Hetty vacuum cleaner.There is no rear roller built into the compatible brush head, so it is not quite as manoeuvrable as an original.There is no protruding piece at the rear of the brush's neck with which, to attach the tubular section (pipework) to the vacuum cleaner when it is stored or parked in use.The suction inlet hole is smaller but wider, than the original and it's design is less efficient as a result.The brush head works well enough but is not as efficient as the original, or quite of the same standard of finish and lacking features.Still it makes a good standby.

Fits well and works

I requested this as the brush head that came with my hoover to say the least was a bit underwhelming and this one looked a hundred times better.I figured it would fit as the description listed various compatible models, but I can now say this unfortunately does not fit the Wickes hoover I have in my shed which I now know has a 35mm diameter.Still all is not lost, I was going to break out the 3D printer and print an adapter until I saw one on Amazon for a couple of pounds and that is on its way as I type.The brush head itself looks good quality and is well made with a metal base plate and a 2 height brush mechanism, just got to wait for the adapter to use it and throw away my old rubbish one.