Manual Adjustable 1-5 PSI Fuel Pressure Regulator Carburetor Carb Fuel Pump Kit with 0-15 PSI Pressure Gauge and Fuel Block

so far so good has not leaked yet holding presser down to 2lbs

According to the gauge which was furnished with this fuel pressure regulator, it regulates nothing. The fuel pressure stays the same at any setting chosen. It leaks fuel also. This is junk and Amazon should remove it from inventory and issue refunds to anyone who has purchased this item.

fixed the flooding problem

Used this to make my own return line on my 90 k1500 that has been swapped from throttle body to carbureted. I used 3/8 rubber fuel line, a 3/8 barbed, T junction and this dead head fuel regulator. I have fuel coming from the fuel pump to the T, then have the regulator running to the fuel return line. The other side of the T goes to the fuel gauge, then to the carburetor. I opened the fuel pressure regulator all the way and it holds 5 1/2 to 6 1/2 psi to the carb. It works great. All the extra fuel goes back to the tank. The fuel gauge does seep a little fuel at the back of the gauge. But this whole set up only cost me around $40.

Junk, broke after 2 days

Hoses crack in a few weeks. Regulator leaks.

The gauge and regulator seem to be working fine however the fuel line included is trash it is not ANSI certified line the fuel eats it from the inside now I have a carburetor full of rubber mess I probably won’t ever get out so long story short would have been better not to include the fuel line if it wasn’t the required application.

Running my machine and smelled gas. Looked inside the engine compartment and this piece of garbage has broken and is spewing gas out all over the hot engine. Used with a 7 PSI electric fuel pump and it could not reduce the pressure to 3 psi without blowing up. Worthless piece of junk.