Shower Door Bottom Seal, 2 PCS 3/8" x 36" Shower Door Sweep for 3/8 Inch Glass, Frameless Glass Shower Door Seal Strip, Stop Shower Leaks and Create a Water Barrier

This threshold/gasket works really well to divert water that is running down a glass shower door back into the shower. Make sure you measure the thickness of the glass to get the proper size. Pro-tip: When installing, put a few drops of soap or shampoo on the gasket as you slide it on.

Redid a shower at my home. Needed to replace my shower door trim. This stuff fits perfectly, and keeps the water in the shower.

I installed this on my shower door. It fits well and the material appears durable.The only downside is cutting the material to the size of my shower door. It’s very difficult to cut to size. I tried a box cutter and scissors without success. I ended up using a pipe cutter which did the trick, because it holds it down while the blade makes a clean uniform cut. It was easy to install after that.I hope it lasts longer that the manufactured door seal that was installed when the house was built 4 years ago.

This think work fantastic on keeping the water in the shower and not on the floor

Perfect fit! Shipped quick and installation instructions were outstanding!

It’s good. Does the job.

If I look at my Amazon history, I have replace the sweep about 4 times over the years. The problem was always that water was seeping out under the glass shower door. The water would work its way to my cabinet on one side and the bathroom door on the other. Replacing the seal helped some, but leaking has always been an issue. This time I got the bottom seal for the first time because it was suggested by Amazon. I ripped out the existing aluminum bottom seal and replaced it with this semi-circle acrylic one. This was huge improvement. The shower threshold is now completely dry for the first time ever. It was expensive to get both the sweep and the bottom when you consider you are just getting a few ounces of plastic, but I am very happy with it despite the cost.

The two-piece design is a good idea, but didn't work out for my shower door. There isn't enough clearance between the bottom of my shower door and where the bottom strip goes for me to use the acrylic bottom piece. The door seal plastic is very difficult to cut, and the bottom fins are not long enough to fill the gap beneath the door. The design of all these shower door seals also don't consider the metal casing at the hinge end of a door which is wider than the glass. A custom cut is needed for that area, and as mentioned this material is not easy to cut. I ended up not being able to use this product at all and cannot be returned because it has already been cut to fit my door. $30 wasted.