DEWALLIE Honeycomb Laser Bed, 18.5x17.32x0.87'' Honeycomb Working Table for Xtool D1 and D1 Pro Laser Engraver and Cutter, Fixture Design & Table-Protecting, Black

Having used several different laser honeycombs in the past, this one seems to be one of the better designed and built ones I've tried. The corners are nice and square and come with plastic protectors. And it came with an aluminum under-tray that protects the surface beneath it, a feature missing on most all other honeycombs. Most importantly, it has a proper gap underneath between the honeycomb and the tray for venting smoke and vapors, which is important for cut quality and to prevent fires.The fixturing clamps are nice and adequately hold down stock material. And the honeycomb is sized correctly with a full 400x400mm work area and the listing correctly notes its real physical dimensions of 440 x 470 x 22mm in the product description -- this is an important detail that's often listed incorrectly on many other honeycomb sellers and you have to double check to discern physical dimensions from work area dimensions.The ruler markings for the workspace are a very convenient addition and provide a better reference than the ruler markings on my laser itself, since this ruler is closer to the actual stock material. Most of the other honeycombs I own are completely lacking this feature.It fits my new AtomStack A20 Pro laser very nicely, and it should also work on the other model AtomStack lasers with the same size gantry space.The only thing I think I would change on it is the wingnuts for the clamps. Even though the wingnuts are very convenient for adjusting, depending on where they end up when tightening them, they can protrude just past the side of the honeycomb and you have to be careful they don't collide with the Y-axis of the laser (depending on what particular laser you are using and how it's designed). So, I might replace them with a different fastener at some point.Overall, though, this is a very nice honeycomb.

This item is recommended!

The media could not be loaded. This may have been partially due to my own ignorance so I gave it a 3 instead of a 2 star rating. I was replacing my smaller bed with this one which turns out to be structurally quite week and bends with weight. I put a 3/4 " piece of 5x7 MDF I was using as a backer/guide for Something and it wasn't sitting flat. I did put 4 half-inch feet on this one which it doesn't ship with. I can't imagine using it without as the smoke will trap in the cells and "flame". I raised it 1/2 off the bed for air flow similar to my other one which appears to be maid of stainless and much more stable then the this aluminum one.

It works fine but the box was torn and some of the bolts meant to attach the hold down arms were missing. You have to be careful as the bolts stick up a lot further than necessary and can interfere with the carriage if you're not careful. In retrospect a steel one used with magnets might have been a better choice. At some point I'll have to find some shorter bolts or cut the existing ones down.

The media could not be loaded. Be careful when ordering fromthis company, stuffs like this can happen. But overall the product is great.