Neutrik NC3MXX 3-Pin XLRM Cable Connector, Nickel Housing with Silver Contacts

Easy to solder to, they fit the mating connectors. Seemingly well made.

Easy to assemble, sturdy. Easily soldered, clean signal over a few years of use.

These are the most rock solid connections I can make with my microphones or audio gear. My only complaint is screwing the boot on is very difficult.

I used this plug and socket to provide an elegant solution to the problem of my wired thermostat required for my Quadrafire pellet stove. I needed a plug in 3 wire connector and this worked flawlessly. It looks so good I can't believe I waited so long to do this.

Title says it all

You can make your own terminator with this brand but you probably need the female version for that. The connectors, male and female are good quality and secure a cable nicely. The silver contacts are good enough for DMX lighting cables. Note you can used these to make balanced mike cables too but the cable material for DMX lighting MUST be chosen for that spec. The MIC cables would have a different characteristic impedance than DMX cable. If you are confused, search "different in DMX and Mic cable"

its fine

Are you serious at an outdoor range in Florida. The connectors are outside 24/7 and hold up to the elements with a little bit of dielectric grease in them. These are far superior to other XLR connectors in the same price category.