Creality Ender3 / CR-10 Pin 27 Board for BLTouch or Filament Sensor BL Touch by Print3d LLC

Almost every installation instruction I read for the BLTouch said I had to swap the wires before connecting to the 27 pin board. This adapter swapped them already, so definitely almost fried my system. The pin adapter is working great though.

This is a great little solution for avoiding soldering and maintaining reversability on the Creality Ender 3 when installing a BL Touch for auto bed leveling. I was about to cut into the display ribbon cable, etc. when I saw Teaching Tech's guide on Youtube on using this to get access to the pin on the ribbon cable without cutting it. Very straight forward setup once you have this, and makes for a very clean install. I recommend it.

It plugs into the Ender 3 board. The biggest problem is that, the connector for the BLTouch is bent at a right angle. This means that the cable for the BLTouch is crammed up against the frame when you put the control panel back where it goes. I worked around this problem by adding spacers. I imagine re-soldering the pin connectors with straight pins would work too (but if you're getting this board, you're probably averse to soldering).

The board I received is a later version that has the two pins reversed so you don't need to repin your connector. Made installing my BLTouch so much easier!

It works as intended, but since my 3D Printer can't use the BLTouch, this thing is practically useless.

First one had a manufactured error. Didn’t find out until after I was able to return. Seller sent a new one with no problem.

It does exactly what it is supposed to do and works really well. My only complaint is that it sits pretty loosely on the pins.

Not much to say about it. This is one of those it works or it does not.. Well it works...