Apoc Dodge Ram adjustable controls arms are a great upgrade from stock, factory controls arms work great with factory sized tires and suspension but once you go bigger you need stronger and longer controls arms to maintain correct handling. Apoc Dodge control arms are built to maintain proper suspension and steering geometry to keep your truck feeling like stock but better. When adding any amount of lift to a Dodge Ram you change your caster angles which can create dangerous steering symptoms and harder to maintain proper wheel tracking which can cause your vehicle to wonder between the lines easier. Big tires and big lifts look great but don't sacrifice handling and create a beast to keep on the road upgrade you control arm and drive with ease. Adjustable Controls arms are fully adjustable from stock all the way to 7" of lift, so if your just starting with a mild lift for now but upgrading later, these arms will suit your needs as you add more lift over time. Parts Included: 2 Upper Control Arms 2 Lower Control Arms Top Quality Polyurethane Bushings .250 Wall Tubing Bushing Ends DOM Tubing Uses Factory Hardware Grease Fitting For Each Bushing For Long Life Install Time: 3-4 Hours Basic hand tools Jack and Jack stands Control Arm lengths If you are upgrading from factory control arms make sure you set the length to the correct lift size to keep your steering geometry correct. The larger the lift the longer the control arms. Don't assume what your lift size is, if you are not sure contact the lift kit manufacture to verify your lift size. The Instructions will give you the measurements to set each control arm to match your lift, an alignment is reconmended after install to insure all alignment angle are proper.
J**N
Triple check measurements then smooth sailing.
Not bad at all the bars are not built semetrical but after adjusting to proper lengths they’re fine. The bars did move my axle forward to center and fit pretty well. Professional installation definitely recommended luckily I’m a mechanic. Personal recommendation. Upper arm jamb nut towards the axle and lower arm jamb nut towards the frame so you can tighten them properly once installed.
R**U
2003 dodge ram 3500
Lets start with the pros. These things are built like OEM tank equipment. Easy to install. Fully adjustable from stock measurement to 6" lift. I could not find another competitor that did this. They look awesome while doing a better than stock job. More then fairly priced.The cons. Getting the old ones off sucks. Have plenty of Sawzall blades, air hammer, time, and beer on hand. The adjustment nuts end up tucked up into the "cradles" that the bars are mounted to. All adjustments will need the bars to be unbolted and lowered for access to the nuts. The grease fits are not the right angle, had to get new ones or I would not have been able to get on them to grease. The upper bar also could not be installed the way the direction sugjest because of grease fitting placement.I replaced these bars along with alot of other front end parts hoping to fix the dreaded death wobble in my 2003 3500. OEM front end conversion kit, steering stabilizer, wheel bearings, upper/lower ball joints, and a power steering box brace. I know every situition is different but in my cause I am sure these bars were my problem. shortly after starting the job we discovered the upper arms were seriously compromised. Driver side broken inside the cradle which you can not see. Passenger upper bolt broken.
J**N
The best Arms I've seen!
Perfect fit 2007 Dodge Ram 2500 Mega Cab 4wd 5.7 2.5in. Lift.Very cool looking arms & the are super Heavy Duty!Will definitely buy again.
C**R
quality
works great. if u are not comfortable doing this job u probably don't need to do it have a shop do them. u will need an alinement to get proper clearance but are a lot better that factory. Also they r adjustable which helps with lifted trucks. Have greaseable bushings. They will out last the whole truck.
Trustpilot
3 weeks ago
2 weeks ago
