TMC Electric Toilet Macerator Conversion Kit with Threaded-On Hose Connection Includes Macerator Pump, Toilet Base, On-Off Control Switch, Hose for Boats, RV, Camper, Trailer, 12V - FO728

Works great

Marine head

So far, so good... haven’t used it long, but it doesn’t mess around! It chews up crap and toilet paper like no joke! It also completely clears the hose so there is no residual smell.

Shipped fast. Arrived early. Easy install in 20 min. Quiet flush compared to others. Fills holding tank quickly as raw water intake hoses are 1" diameter as well... Aside from that, awesome...

Everything you need to replace your head. Works but flushing solids often creates little balls that will not flush easly. Did not have this problem with the Jabsco electric head. I believe the chopper blades (also act as impellor) should have more pitch to them to create a stronger suction.Update: 9 months now and can't recommend this product. Simply less and less effective every day. Macerator does not macerate which leaves stuff stuck in the joker valve which causes joker valve to leak contents back into bowl.

Works great but loud.

Lasted 3 years almost to the date. Motor is not powerful enough to operate. Not sure if it is the motor or pump or a combination of both. Will not buy another one.

This is great value but it could be troublesome to install. I used it to convert a Jabsco manual toilet to electric flush. Attaching the base to the Jabsco bowl was easy. You can rotate the base in 90 degree increments to fit your space. All hose connections are 1" and while the adapters are included with the kit, the whole installation becomes complicated, especially if you are aiming for the most compact installation. I ended up using about 10 clamps. It would have been so much simpler if the flush water connections were the standard 3/4" ID.Next, the motor attaches to the base of the bowl with four bolts. These were not tight from the factory and I did not check them. After I finished the install one of them was leaking. At this point you cannot fix the problem by tightening the bolts because the gasket would have already unseated itself. So I had to remove the hoses and the clamps (a pain), remove the motor assemble, re-seat the gasket and tighten the bolts. Afterwards it worked like a champ and it is not loud at all.I am giving it four starts because it is good value for money (half the price of Jabsco unit) but once you get the unit, make sure that you remove the motor, check the gasket, then tighten the bolts, You will save yourself a lot of frustration later. My advice to the manufacturer is either tighten the bolts well or sell the unit disassembled, so that the customer can verify the seating of the gasket.The best part about this unit is the single button operation. Nice and easy. The switch that comes with the unit feels cheap and unattractive, I suggest you use a regular push button switch.