YGS-Tech 2 Inch LED Recessed Lighting, Dimmable Downlight 3W(35W Halogen Equivalent), CRI80, 3000K Warm White LED Ceiling Light with LED Driver(4 Pack)

Decent quality. They work well and previous purchase stillborn strong. Great light output for the size (you dou need to understand lumens or candle power to decide if the correct size, they definitely will be purchased again.

I gave the lights an overall five star review because any minor issues were reasonable in light of the cost. I purchased them to give the floating shelf over a reading chair a little more light. I was debating using three or four lights that come with it. I could have gotten away with two. The installation was a touch tricky as the brackets meant to hold lights in place required a slightly larger hole than the two inch hole bit with which I drilled. Also, the wire clips were a touch useless and had to use my own wire nuts.

Lights look quite nice. Installed as follows:1. Cut off wire connectors on lights.2. Wire nut together in chain with 18/2.3. Cut and strip all wires on one transformer.4. Wire nut power end and 18/2 end to transformer ends.5. Wire nut other end of power to switch (mine was a wifi dimmable light switch).Note: I used small wire nuts and all four closed back up in the transformer. Yes, one of the tiny transformers that comes with this set. I screwed that to the underside of the cabinet. If you can’t do that, can get a larger led transformer for $10 that can fit wiring nuts inside of it. I will get a bigger transformer anyways soon and just replace this one.

They eventually all fail rather quickly (months to a couple of years) and begin to fade and strobe epileptically, turning your grandma's kitchen into downtown Miami's Club Space! I guess that's a bonus feature? 🤷‍♂

If you have never done electrical work before then you need to consult an electrician. THESE LIGHTS ARE NOT UL LISTED FOR AMERICAN USE. These lights have connectors on them which i believe could cause a fire hazard down the road. Remove them and use wire nuts to splice the connections, then use to electrical tape to tape the splices. The holes you need can be drilled out with a 2 1/4 inch holesaw.I personally knew these lights would be a little on the unsafe side but knowing where the hazards are is key. I bought these to replace my fluorescent light over my sink and they work perfectly fine.

Super easy to install. I daisy chained 3 of them together above the kitchen counter. My only issue is using them with a dimmer switch. At the lowest setting, the lights have a noticeable flickering. Also, every time you turn the lights on, they flicker on, off, and back to the dimmer setting. I've tried troubleshooting with the dimmer switch's settings but have not found a solution.In my case, these work fine. They do the job, and despite the issues, you get what you pay for.Honestly, I may switch to a light that is more recessed in the future, as these lights are visibly bright LEDs in your peripheral vision from any direction. At least they aren't too dim.

These are great lights. They provide great light. I had very little trouble installing them where the old lights were. The only issue I had is with the provided connectors not holding the wires very securely at first. It was easy to pull the wires out when moving things around.

Lights worked fine, but one burned out in 8 months, a second one in 1 year.

Se calientan un poco.Funcionan bien

Quoi dire de plus, le prix est très juste et bonne qualité, je suis très satisfait! Remplacement parfait pour mes anciennes halogènes qui dégageaient beaucoup de chaleur.

Simple to install. Top quality appearance. I’ll buy them again.

Lights work great, even on a dimmer switch. No flickering. The wires are to short to get into a box and terminate easily. Connectors aren’t great to connect to 14/2 wire. In Canada we need to have the terminations done in a box and these light make that tricky, but possible.

No install issues...so far so good i like the product and is as advertised