NV752 AZ1002 Replacement Filter for Shark Rotator APEX DuoClean Powered Lift-Away Vacuum AZ1000 AZ1002 AX950 AX951 AX952 NV650 NV651 NV652 NV751 NV752 NV831 NV835 ZU632 Part XFF650 XHF650

Perfect for my Shark Duo Clean. Very easy to install.

Fit like it should. Good product

Fits perfectly. I keep extras on hand and replace my filters because lets face it when you wash the original does it actually get clean and smell nice. It’s cheap enough to just replace.

Attractive, nice size, width for narrow spots. Great suction, Very heavy for me, (a short, old, grandma), hard push forward and to pull backwards. Somewhat clumsy for turning, but GREAT for straight ahead, super deep cleaning. Lift off hose is short but would buy a longer one, if available, as an accessory. I have the under couch/appliance wand which is wonderful. I usually end up using my Bissel stick vac for everyday quick cleaning and my old Kenmore cannister for edges, corners, tight spots, and car cleaning. I would buy this again and put up with the minor nusences, but would like it better if it was self propelled forward and backward even if it cost more. My daughter-in-law has the larger model and she has said it's heavy for her also.

Ordered these filters for my Apex DuoClean model AX951. I saw a number of other kits available that included the front roller. Unless your roller is coming apart then I don't see the need to replace the front roller. Simply pull the cover every once in a while and clean the debris that has collected there. I've had my vacuum going on 60 months of pretty heavy use and the roller is still A-OK. So, that prompted me to order this kit. Front filter fit perfectly as did the two filters in the canister area. The round foam filter appeared just ever so slightly smaller in diameter than the original. I mean EVER SO SLIGHTLY. So much so that it might have been an optical illusion when comparing or the old factory filter had just stretched from use. Installed no problem and works just like the original. I've seen some reviews on the filter not filling up the entire canister area. At least on the AX951 models, the filter does not fit and fill up the entire canister area. Even the original one didn't and is designed not to. All the filter needs to do is to fit over the center perforated cone area. This is where the air flows through. The bottom of the plastic cone seals to the bottom of the canister area. The air is drawn through the foam, through the plastic cone perforations and then down through the wafer filter that is in the bottom before it is pulled through the motor. It then exists out of the front filter. I looked really closely at these replacement filters, their fit and tested how they worked with my vacuum. They work just like the originals. I'm seeing no noticeable reduction in suction. The canister fills with the same sort of dust and debris that it always did. So, I'd have to say these filters are a hit. I wash my canister filters out after every use. Getting new ones certainly illustrated how worn and dirty my old filters were even following this procedure. Recommended.

Súper práctico

Perfect fit for replacement filters. They are just like the original. Easily replaced the old ones.

Buen producto