Flexyframe LD - Front Bumper Guard, Front Bumper Protection, License Plate Frame (2-pack)

despite what some of the reviews say, I am very happy with this product and am most happy that I ordered the two pack. I placed one on our 2013 Toyota RAV4 and the other one on our new 2018 Subaru Crosstrek. Installation was a breeze on both vehicles with the Subaru using the screws that came with the product that fit perfectly into the mounting holes directly on the front bumper and with the RAV4 using the machine screws that came with the mounting fromae on the bumper that had mounting brackets which the mackine screws screwed into....both were most easy to install and involved two top screw mounting to the vehicle.....while is is true what one other reviewer has written that the soft rubber of which this product is made attracts dirt, it can easily be washed off in an ordinary car wash and then looks like new.....both look just terrific

These are GREAT!!!! We bought a 2016 Toyota Prius and the bumper is nearly flush with the point on the hood and is very hard to see. Installed this and it gives us an extra inch of clearance as I park in the parking garage at work. Paired it was a decorative plate and it is hardly noticeable!

I was looking into license plate bumper guards and wanted to try these . The rubber is too soft , get dirty easy , it DOES NOT fit correctly , there is no bottom bolts for my car and i used the rubber plugs on the bottom to lock the plate in and bolted the top . The bottom stuck out and top pulled in so it was not flush looking . Looks terrible , the so call cover the hide the bolts when tighten fold outward? Should have paid more for a better brand.

The only frames you should use. Very well made, easy to install takes a beating, and lasts very long. Highly recommended.

It's a little tricky getting the lower inserts into the plate holes but beyond that quality is good and it works well.

This is a great front end bumper protector. I had purchased 3 sets for 3 different cars. They do work

Junk! I tried using all four mounting screws, that requires permanently removing the two rubber tabs on the bottom of this ill fitting piece of rubber and because the piece of junk does not fit properly it pulls the bottom away so far that the screws show. Leave this one alone, that's my suggestion....

any idea how to remove rubber pegs from 4 screw installation? i can't. not sure what to do?